User manual MORLEY PEDALS BVOES

[. . . ] We know you will appreciate the rugged construction of your Morley®. Most of all, we hope you enjoy using it as much as we enjoyed building it. CONNECTIONS BATTERY REPLACEMENT 9V: Connect 9 volt DC 300 milliamp regulated adapter to this jack. Plug instrument into this jack using 1/4" guitar cable. [. . . ] Plug instrument into this jack using 1/4" guitar cable. OUT: Connect amplifier to this jack using a 1/4" guitar cable. NOTE: You'll find cords fit very tightly into our input and output jacks. The tight fit helps prevent the cord from becoming accidentally unplugged from the pedal. Make sure the cords are completely plugged in for best results. AC ADAPTER Use 9-volt Dc 300 milliamp regulated adapter only. Using a non-regulated adapter could cause a low frequency hum in your amplifier and may damage the pedal. Just stepping on the spring loaded pedal actuates it; the pedal automatically goes into WAH mode. Remove your foot and the pedal springs back to bypass mode. The BVOES also has a classic lead sound that attacks each note with a higher frequency response than our Pro Series WAH (PWA). The BVOES will make each note soar and carry your leads to new heights. Our unique electro-optical design ensures smooth overall control. Here is a general recommendation for hooking up a WAH with other effects: NOTE: This pedal is not intended for use through an effects loop (send and return). FEATURES · Electro-Optical: The amount of light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique electro-optical design ensures smooth overall control of the WAH without unwanted noise typical with potentiometer (pot) controlled pedals. Electro-Optical Switching: Your pedal features electro-optical switching circuitry that allows the BVOES to go into WAH mode without actuating a switch. [. . . ] Our unique electro-optical design ensures smooth overall control. Here is a general recommendation for hooking up a WAH with other effects: NOTE: This pedal is not intended for use through an effects loop (send and return). FEATURES · Electro-Optical: The amount of light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique electro-optical design ensures smooth overall control of the WAH without unwanted noise typical with potentiometer (pot) controlled pedals. Electro-Optical Switching: Your pedal features electro-optical switching circuitry that allows the BVOES to go into WAH mode without actuating a switch. [. . . ]