User manual MORLEY PEDALS CCB

[. . . ] CONNECTIONS BATTERY REPLACEMENT When the battery becomes weak, the overall chorus effect will become weak and your signal may become slightly distorted. Remove the battery door located on the bottom of the pedal. [. . . ] STEREO OUT: Connect a second amplifier to this jack for stereo chorus. 9V: Connect Morley 9 volt regulated AC adapter to this jack. NOTE: You'll find your cord fits very tightly into our input and output jacks. The tight fits helps prevent the cord from becoming accidentally unplugged from the pedal. Make sure the cords are completely plugged in for best results. WARRANTY All Morley® pedals are warranted for two years from date of purchase. To obtain warranty service call 1-800-639-4668. CONTROLS The Crystal Chorus has two controls: DEPTH & RATE. Understanding these controls will help you to get the sound you are looking for. The DEPTH control adjusts the amount of Chorus present in the mix. When the stereo output is used it will also enhance the stereo spectrum between the two amplifiers. Refer to the sample settings section of this manual for hints. [. . . ] When the pedal is not used for extended periods, we recommend you remove the battery from the pedal or replace it every six month to prevent leakage problems. 185 Detroit Street, Cary, IL 60013 Phone:(847) 639-4646 Fax: (847) 639-4723 www. morleypedals. com Below are a few settings you can try to get started. The names used below are very general. CRYSTAL CHORUS Here is a general recommendation for proper hookup of an effects chain: MODEL CCB NOTE: This pedal is not intended for use through an effects loop (send and return). OWNER'S MANUAL [. . . ]