User manual MORLEY PEDALS CFWES

[. . . ] Plug instrument into this jack using 1/4" guitar cable. OUT: Connect amplifier to this jack using a 1/4" guitar cable. Morley Pedals (except Model PLA) are NOT recommended for use in effects loops. NOTE: You'll find cords fit very tightly into the input/output jacks. [. . . ] The tight fit helps prevent the cord from being accidentally unplugged. Make sure cords are completely plugged in for best results. ELECTRO-OPTICAL CIRCUITRY (ALL PEDALS): The light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique Electro-Optical design ensures smooth pedal control without unwanted noise typical with potentiometer (pot) controlled pedals. AC ADAPTER (ALL PEDALS) All Morley pedals use Morley's 9VDC 300 milliamp regulated adapter. Using a non-regulated adapter could cause a low frequency hum in your amplifier. Using an adapter with the wrong polarity may damage the pedal. BATTERY (ALL PEDALS) All Morley pedals are designed to use one 9V battery when not using an adapter. We suggest you use a good quality alkaline battery. If you would like to adjust the off time, follow these steps: 1) Remove four bottom cover screws and bottom cover. 2) Locate trim-pot labeled "WAH OFF DELAY" (it is about 3 inches up and about 1-1/2" left from the center heel end of pedal. 3) Use a miniature screwdriver (like the ones used for eyeglasses) to turn the center adjustment of the trimpot to customize it for your setting. 4) Turning the trim-pot clockwise shortens the off delay time. Counter-clockwise lengthens the off delay time. The off delay time can be adjusted from instantaneous up to 3. 5 seconds. 5) If you have questions about this procedure, feel free to call 847-639-4646 (ext 14). VAI-1 SPECIFICATIONS POWER: 9 Volt Battery or Morley's 9VDC 300 milliamp regulated adapter (center pin in negative) CURRENT DRAW: 12 mA @ 9 VDC WEIGHT: 3. 3 lb. / 1. 51 kg INDICATOR: Wah effect on or Bypassed BAD HORSIE 2 CONTOUR WAH FEATURES (MODEL VAI-2) The VAI-2 is a Bad Horsie Wah with the additional choice of CONTOUR mode. Click the footswitch to the left of the foot pedal to engage CONTOUR mode (the left side LED turns ON). [. . . ] VAI-1 SPECIFICATIONS POWER: 9 Volt Battery or Morley's 9VDC 300 milliamp regulated adapter (center pin in negative) CURRENT DRAW: 12 mA @ 9 VDC WEIGHT: 3. 3 lb. / 1. 51 kg INDICATOR: Wah effect on or Bypassed BAD HORSIE 2 CONTOUR WAH FEATURES (MODEL VAI-2) The VAI-2 is a Bad Horsie Wah with the additional choice of CONTOUR mode. Click the footswitch to the left of the foot pedal to engage CONTOUR mode (the left side LED turns ON). The contour mode allows you to alter the Wah tone and level. · · · · · · CONTOUR control: Adjusts the tone (shelving) of the Wah when in CONTOUR mode. LEVEL control: Adjusts the Wah output level in CONTOUR mode. [. . . ]