User manual MORPHY RICHARDS 42302 STEAM GENERATOR

[. . . ] RN42288MUK Rev7:RN42288MUK Rev7 04/11/2009 10:28 Page 1 Upon registration with Morphy Richards (UK & ROI only) Register online for your 2 year guarantee. See back of this instruction book for details. (UK and Ireland customers only) www. morphyrichards. co. uk Jet Steam `Elite' & Jet Stream Range Please read and keep these instructions ironing system Getting the best from your new ironing system. . . . Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. Water tank (certain models are illuminated) The water tank can be re-filled at any time during ironing. [. . . ] The iron's temperature indicator light ¤ goes off when the required temperature is reached. Depress the steam button / for 1 minute to clear the system of air (first time use only). This will be accompanied by a clicking noise which is quite normal. Begin first time ironing with an old towel. Note: If you press the steam button before the steam generator reaches its required temperature, a warning double beep will sound. The appliance is ready to use. FILLING B 1 Place the steam generator on a stable ironing board or table, with the iron resting on its stand. Release the detachable water tank by operating the tank release knob , , . Fill the tank to the `fill to here' line with clean tap water A. IN HARD WATER AREAS, THE USE OF DISTILLED OR DEMINERALISED WATER IS RECOMMENDED. Never use battery topping up fluid or water containing any substances like starch or sugar, or defrosted water from a refrigerator. 5 Re-position the water tank on the base unit and push securely into place. Always pour out any remaining water after use. 2 LOCATION Locate the steam generator horizontally on the rest plate of your ironing board (if large enough) or on a heat resistant stand at the same height as your ironing board or below it. Always ensure the generator is on a firm surface when ironing. WARNING: Do not use the product on a surface which could be damaged by heat or steam such as a worktop or a polished wood surface. If in doubt, contact Morphy Richards. 3 4 BEFORE USE Remove any protective sticker from the soleplate and the base unit, if any. Unwind and straighten the power cord and supply cord fl. Slide out the water tank · and fill (see filling instructions). When ironing with the iron temperature set at 2-dot setting, the steam output should be set at the lower end of the steam range (on certain models only). Textiles and clothes are supposed to carry ironing instructions. If they don't, you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. 6 Re-filling `in use' 1 The low water indicator light Ê will flash and a beep sound will be heard. This is a warning to stop ironing and fill the tank. [. . . ] If, for any reason, this item is replaced during the 1 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase. To qualify for the 1 year guarantee, the appliance must have been used according to the instructions supplied. For example, crumb trays should have been emptied regularly. 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). [. . . ]