User manual MORPHY RICHARDS 48430

[. . . ] Compact food processor Two year guarantee This guarantee is valid in the UK and Ireland only. It is in your interest to retain the retailers receipt as proof of purchase. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. [. . . ] The blades and disc holder can now be placed into the bowl. Refer to `fitting and using the tools' section which follows. Holding the cover by the feed tube, fit the cover by rotating clockwise firmly until the cover, bowl and the base unit interlock. Safety interlock Fitting and using the tools All tools which are fitted within the processor bowl must be firmly connected to the hexagonal drive shaft in the centre of the processor bowl. Always adjust the tools until you are sure that they are correctly fitted. Metal and plastic blades 1 With the processor bowl already fitted, place the blade over the hexagonal drive shaft of the processor. Lightly turn the tool until it engages onto the drive and the blades are close to the bottom of the bowl and level. Holding the cover by the feed tube, fit the cover by Safety rotating interlock clockwise. Ensure that the safety interlock has clicked into place. 2 2 3 4 Slicing, and grating plates 1 With the processor bowl already fitted, place the slicing or grating plates into the plate holding disc. The plates should be placed into the disc as shown and clicked into place. (will only fit one way) Place the plate holding disc onto the shaft (with the thinner end at the top) onto the central drive shaft of the bowl and check that it is firmly fixed in place. Holding the cover by the feed tube, fit the cover by rotating clockwise. Ensure that the safety interlocks have clicked into place. (see setting up the processor) Plug in the processor. PLEASE NOTE: When using these discs, never introduce the fingers into the feed tube. Always use the food pusher. 2 Turn the strainer clockwise until the Safety interlock strainer locks into the safety interlock. Drop the citrus press drive onto gear the drive shaft. 3 2 4 3 Drop the small citrus press into the citrus press support post . 4 5 Using the citrus press 1 With the empty processor bowl locked in place, drop the strainer into the top of the processor bowl. 6 If the large citrus press is required drop the large citrus press over the small citrus press. Plug in the processor and select the speed required. Dismantling after use 1 2 3 4 Unplug the processor. Remove the processor bowl cover by turning anti-clockwise. Carefully remove the blade/disc and shaft/citrus juicer. Remember - the metal tools are very sharp. Unlock and remove the processor bowl. 5 Hints and tips · · · · The metal blade can be used for chopping meat, fish, vegetables, cheese etc, setting the speed to maximum. For finer chopping, increase the length of time you process. [. . . ] Add water gradually and process until the pastry forms a ball. Leave pastry in a cool place for 30 minutes before using. Makes 350g (12oz) pastry. 7 Fruit cake 100g (4oz) butter or margarine 100g (4oz) caster sugar 2 eggs, beaten 225g (8oz) self raising flour 60-90ml (4-6 tbsp) milk 5ml (1tsp) mixed spice 225g (8oz) dried fruit Using the dough blade, place the cubed margarine and sugar into the processor bowl. Mix until soft and creamy, scraping down the sides of the bowl as necessary. [. . . ]