User manual MORPHY RICHARDS 70460 GRIMEBUSTER INSTANT STEAM CLEANER

[. . . ] · When using the machine always keep it horizontal. · Steam must not be directed towards equipment containing electrical components, such as the interior of ovens. Other safety considerations · Do not use any chemical detergents, perfumes, alcohol etc in water. · Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. [. . . ] 1 Ensure the safety lock ¤ is off. When the lock is pushed towards the rear the trigger cannot be activated. Push the lock forward to release the steam trigger. 2 When you press the steam trigger, steam will be emitted from the nozzle. H 3 There will be an initial delay of a few seconds before the water reaches the boiler. This delay is indicated by the pump noise and reduces as water enters the system. IMPORTANT: On the first use it may take up to 30 seconds before steam is released. If steam is not released within 30 seconds remove and refit the tank, then re-try. 4 Keep the steam trigger pressed and direct the steam at the surface to be cleaned, removing the dirt by moving the steam jet backwards and forwards over the area. 5 To stop the steam jet, release the steam trigger. There will be a delay before the steam ceases as the remaining water in the system is expelled. Make sure the steam nozzle is safely held/located during this period. 6 When the water reaches a low level the pump will click, this is due to air being pumped instead of water. Stop using the appliance, locate the steam nozzle in a safe location and refill the tank. It is not necessary to wait for the appliance to cool down. IMPORTANT: If the pump is run dry for a long period it may become air blocked. If this happens, switch off or leave the unit to fully cool before re-trying. Attaching tubes and handle WARNING: Allow all parts to cool and make certain steam has stopped before attempting to fit or change any accessories. 1 Pull the flap down that covers the inlet. Push the plug firmly into the inlet with the arrow facing upwards I. large floor brush, jet nozzle or the extension tube directly to the hose handle depending on the application. H I 5 70460 Rev 2 10/8/04 10:44 AM Page 6 3 To join extension tubes together, slide one tube into the other until it locks in place J. 4 Attach the two tubes to the handle of the hose. Slide the handle into the extension tube until it locks in place. Some tasks may be easier with only one tube fitted or none at all. [. . . ] See table below for recommended replacement intervals. In very hard water areas distilled water could also be used. WARNING: Do not use any descaler solutions in this product. 7 70460 Rev 2 10/8/04 10:44 AM Page 8 Two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. [. . . ]