User manual MORPHY RICHARDS 73355 PERFORMAIR ENDURANCE UPRIGHT VACUUM CLEANER

[. . . ] Never use in the presence of explosive liquid or vapours. Never pick up inflammable or poisonous liquids such as petrol, copier toner or other volatile substances. Never pick up acids, asbestos or asbestos dust. Never touch the plug or cable with wet hands. [. . . ] IMPORTANT: Push the hose connector fully in such that the flap È latches on to the hose connector Ê. 3 Add the required accessory to the extension tubes or directly to the tube connector Ë when using the hose and tools. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. IMPORTANT: Remove the hose connector before returning to floor cleaning with the main nozzle. Push the flap down to disengage the latch before pulling out the connector. Using on carpets 1 2 Place the cleaner in it's upright position. Release the mains cable by turning the quick release cleat  half-a-turn and extend the cable fully. Step on the upright release pedal · to release the handle to the desired position. Press the control switch on the handle to setting `II' (carpet). Note: The beater bar will automatically switch off when the cleaner is parked upright. IMPORTANT: To prevent damage to carpets, never leave the cleaner switched on in one place for an extended period. C 3 4 Ê 5 · È 4 For Advice, Spares or Accessories, tel: 0845 077 7700 (UK) or 1800 409 119 (Ireland) 73355 rev3 29/11/07 11:56 Page 5 D Using the Hair and stair tool (Certain models only) Attach the stair tool Ô to the hose connector Ê for effective stair cleaning. FILTERS Using the filter cleaning lever at every emptying will help maintain good suction. However, for a thorough clean, the dust canister and dust canister filters may be disassembled and washed. Ô Attach the hair tool to the stair tool for fantastic pet hair pick-up D. Motor protection filter The motor protection filter Û is located underneath the dust canister H. Lift out the filter and shake over a dustbin. The filter may also be washed in water (no detergents) but must be totally dry before re-fitting. Replace the filter. DUST CANISTER Ê 1 Emptying Remove the dust canister from the product by pressing the canister release button > E. Every time the dust canister is emptied, slide the filter cleaning clicker lever fi several times before emptying F (this will agitate the fine dust between the filter pleats and restore the air flow). Turn the lid quarter-of-a-turn anti-clockwise to unlock, lift off the lid with the pleated filter G. Re-fit the dust canister and push back into position. E 2 3 3 Exhaust filter The allergy exhaust filter should be replaced every 6 months to maintain the high performance filtration. Call our helpline for replacement parts. The exhaust filter is located below the dust canister compartment. 1 Remove the exhaust filter grille , by pressing on top of the latch I. F 4 5 Allergy sufferers G When emptying any vacuum cleaner, it is difficult to avoid exposure to dust. To minimise this risk, please ensure that you encase the dust canister in a large bag to empty it. Close the bag as tightly as possible round the dust canister. [. . . ] This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. This guarantee is valid in the UK and Ireland only. 2 3 4 YOUR TWO YEAR GUARANTEE It is important to retain the retailer's receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]