User manual MORPHY RICHARDS 73387 VACUUM CLEANER

[. . . ] Never pick up inflammable or poisonous liquids such as petrol, copier toner or other volatile substances. Never pick up acids, asbestos, asbestos dust or other hazardous dusts. Never touch the plug or cable with wet hands. Unprofessional repairs can be dangerous for users. [. . . ] Press the power on/off switch ¤ C on the floorhead for the main power. Then press the brush-bar on/off switch < to activate the brush-bar motor for carpet cleaning. 3 D Ë 4 5 È E6 Under furniture cleaning E The unique pivot point on this product allows the whole head to fit under low furniture for better cleaning performance. 4 UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119 73380 rev4 15/2/08 09:23 Page 5 Using the hair and stair tool (certain models only) Attach the stair tool i to the hose connector Ë for effective stair cleaning. Attach the hair tool ^ to the stair tool for fantastic pet hair pick-up F. Allergy sufferers When emptying any vacuum cleaner, it is difficult to avoid exposure to dust. To minimise this risk, please ensure that you encase the dust canister in a large bag to empty it. Close the bag as tightly as possible round the dust canister. Remove the dust canister and close the bag as tightly and quickly as possible and dispose of this immediately. It is advisable to wear disposable gloves and a face mask while emptying the cleaner. If at all possible, ask a non allergy sufferer to empty the dust canister when required. G fi F ^ FILTERS Cleaning i To maintain suction, the pleated filter must be cleaned using the cleaning dial each time the dust canister is emptied. To clean, turn the filter cleaning dial fi clockwise several times G before emptying. H > Ë Pleated filter In addition to cleaning the pleated filter with the cleaning dial each time the dust canister is emptied, it is recommended to regularly remove and wash (or thoroughly brush off) the pleated filter. To thoroughly clean the filter, it can be washed in warm water (no detergent). Ensure the filter is thoroughly dry before refitting. See `Cleaning the dust canister filter assembly' section for a description of how to access the pleated filter. DUST CANISTER Emptying 1 Every time the dust canister is emptied, rotate the filter cleaning dial fi several times clockwise before emptying G (this will agitate the fine dust between the filter pleats and restore the air flow). Remove the dust canister from the product by pressing the canister release button H >. Turn the lid quarter-of-a-turn anti-clockwise to unlock, lift off the lid with the pleated filter I. Re-fit the dust canister and push back into position. I 2 3 4 5 5 73380 rev4 15/2/08 09:23 Page 6 Cleaning the dust canister filter assembly 1 Operate the filter cleaning dial fi several times and empty the dust canister over a bin. To access the filter assembly rotate the dust canister lid anti clockwise and remove from the dust canister J. Turn the central mesh filter ¯ clockwise to remove and clean as required K. Detach the pleated filter ~ from the dust canister lid by a firm pull/twist action L. Both the mesh and pleated filters may be washed in warm water (no detergent). Ensure the filters are thoroughly dry before refitting. Re-locate the pleated filter back into position on the dust canister lid by aligning the tabs on the dust canister lid L with the cut away sections on the pleated filter before pushing into place. 1 2 Motor protection filter The motor protection filter is located underneath the dust canister M. [. . . ] This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. This guarantee is valid in the UK and Ireland only. 2 3 4 YOUR TWO YEAR GUARANTEE It is important to retain the retailer's receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]