User manual MORPHY RICHARDS BREEZE IRON

[. . . ] To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice. Incorrect reassembly can cause a risk of electric shock when the iron is used. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Location · Do not use outdoors. · The iron must be used and rested on a stable surface. [. . . ] WARNING: When filling your iron with tap water always use the beaker provided. A < > fi / , fl · , , / Steam control ¤ Spray button < Shot of steam button (certain models only) > Filling hole with cap fi Spray nozzle fl Soleplate Temperature control dial with indicator · Water tank , Temperature indicator light (red) , , Filling beaker Before use Note: The steam facility should only be used on garments which are suitable for ironing at the 2 and 3 dot settings. When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section). Textiles and clothes are supposed to carry ironing instructions. If they don't you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. Temperature control Plug in the iron and switch on. Set the temperature control dial B to the temperature required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light , which will go on and off while you are ironing. B 4 40310 Rev 2 24/8/07 15:08 Page 5 This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. C Steam No steam Features of your iron Temperature indicator light The indicator light shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. Dry ironing You can use your iron as a dry iron only. Make sure the steam control / is set to the ` ' symbol. Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. Spray Press the spray button ¤ and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Steam control Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be switched from off to on by sliding the steam control C. [. . . ] Please have the following information ready to enable our staff to deal with your query quickly. · Name of the product · Model number as shown on the underside of the appliance. For electrical products sold within the European Community. At the end of the electrical products useful life it should not be disposed of with household waste. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. [. . . ]