User manual MORPHY RICHARDS CYCLONIC BAGLESS UPRIGHT VACUUM CLEANER 73337

[. . . ] 73337 rev1 29/10/08 16:05 Page 1 Cyclonic bagless upright vacuum cleaner Please read and keep these instructions Getting the best from your new cleaner. . . If your cleaner is not picking up as well as it should, please check Dust canister It is important to regularly empty the canister, even if it does not appear full. Filters It is important that the pleated filter is shaken clean each time the dust canister is emptied, this allows air through the appliance. Wash the canister filters regularly in warm water and allow to air dry. Blockages Check the hose, tubes and tools for blockages. Safety cut-out If the air-flow is blocked or the filters are not regularly cleaned, a thermostat may operate. If this happens, switch off and disconnect from the mains supply. Clear any blockage, empty and clean the filters. [. . . ] If additional length is required, attach one or both extension tubes Â. Switch on , , . · · C / · Use the TOOLS setting when using the tools. Note: The height adjustment only comes into effect when the handle is released by the handle release pedal Í. 6 4 UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119 73337 rev1 29/10/08 16:05 Page 5 · IMPORTANT: Always fix the hose clip Ë to the main body slot È when using the hose and tools. Never over extend the hose such that the cleaner is pulled over. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. D Î E ¤ · Ù ^ ~ ¯ i Using the hardfloor nozzle Attach the hardfloor nozzle Û to the two separate attachable tubes. This nozzle is ideal for use on wood, laminate, tile and vinyl flooring. Ï Attach the stair tool Ù to the hose end connector Î for effective stair cleaning D. Attach the hair tool i to the stair tool Ù for fantastic pet hair pick-up D. Attach the soft dusting brush ^ to the stair tool Ù for a softer pick-up D. Attach the stubborn dirt brush ~ to the stair tool Ù to attack stubborn ground in dirt D. Attach the upholstery nozzle ¯ to the stair tool Ù for effective upholstery cleaning D. Using & cleaning the turbo nozzle Attach the turbo nozzle Ú to the hose end connector Î only. WARNING: The turbo nozzle should not be used with the extension tubes. Following use, your turbo nozzle may become clogged. Ensure the vacuum cleaner is switched off and the turbo nozzle is detached from the hose. Turn over the nozzle and pull away any hairs or fibres. If they are tightly wound around the brush, carefully snip the fibres with scissors, being careful not to damage the brush bar, pull away from the brush bar and dispose. To aid cleaning, the turbo nozzle can be opened up by pushing the button on the nozzle forwards. EMPTYING Empty the dust canister regularly even if it does not look full, this will maintain the performance. 1 Remove the front cover < by lifting the cover release lever ¤ E. Lift-up the dust canister release Ï and pull the canister away from the main body. Turn the lid quarter-of-a-turn anti-clockwise to unlock, lift off the lid with pleated filter Ó, put to one side F. Lift out the central mesh filter Ô from the dust canister Ò G. Empty out the dust canister Ò. F 2 G Ó Using the accessories Attach the crevice nozzle Ê to the hose end connector Î or tubes  to access narrow or hard to reach places. Attach the furniture brush Á to the hose end connector Î or tubes for use on pelmets, delicate objects etc. 3 4 5 Ô 6 Ò 5 For details of other Morphy Richards products, please see our website: 73337 rev1 29/10/08 16:06 Page 6 H 7 8 9 Re-fit the central mesh filter. [. . . ] Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. All Morphy Richards products are individually tested before leaving the factory. [. . . ]