User manual MORPHY RICHARDS ESSENTIALS CYCLONIC BAGLESS UPRIGHT VACUUM CLEANER REV 1

[. . . ] 73332 rev1 17/10/07 10:40 Page 1 Essentials cyclonic bagless upright vacuum cleaner Please read and keep these instructions Getting the best from your new cleaner. . . If your cleaner is not picking up as well as it should, please check Dust canister It is important to regularly empty the canister, even if it does not appear full. Filters It is important that the pleated filter is shaken clean each time the dust canister is emptied, this allows air through the appliance. Wash the canister filters regularly in warm water and allow to air dry. Blockages Check the hose, tubes and tools for blockages. Safety cut-out If the air-flow is blocked or the filters are not regularly cleaned, a thermostat may operate. If this happens, switch off and disconnect from the mains supply. Clear any blockage, empty and clean the filters. [. . . ] · Use the TOOLS setting when using the tools. Note: The height adjustment only comes into effect when the handle is released by the handle release pedal È. 4 For Advice, Spares or Accessories, tel: 0845 077 7700 (UK) or 1800 409 119 (Ireland) 73332 rev1 17/10/07 10:40 Page 5 Using the attachments Follow steps 1-4 but set the carpet height adjustment knob to the TOOLS setting. 5 Remove the hose connector Í from the rear of the cleaner. Lift the hose · from the top handle hook. Insert the hose clip ~ into the hose clip slot Ë. Push the required attachment firmly onto the end of the hose. If additional length is required, attach one or both extension tubes. IMPORTANT: Always fix the hose clip ~ to the main body slot Ë when using the hose and tools. Never over extend the hose such that the cleaner is pulled over. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. 1 2 Using the Hair and stair tool (Certain models only) Attach the stair tool to the hose connector Í for effective stair cleaning. Attach the hair tool to the stair tool for fantastic pet hair pick-up D. E · · EMPTYING Empty the dust canister regularly even if it does not look full, this will maintain the performance. Remove the front cover by lifting the cover release lever ¤ E. Lift-up the dust canister release Î and pull the canister away from the main body. Turn the lid quarter-of-a-turn anti-clockwise to unlock, lift off the lid with pleated filter Ì, put to one side F. Lift out the central mesh filter Ô from the dust canister Ó G. Shake the pleated filter to remove all dust. Re-fit pleated filter with lid into the dust canister by lining up the two arrows and turning the lid quarter-of-a-turn clockwise to lock. 6 · · 3 4 5 Using & cleaning the turbo nozzle (Certain models only) Attach the turbo nozzle to the hose end connector Í. Following use, your turbo nozzle may become clogged. Turn over the nozzle and pull away any hairs or fibres. If they are tightly wound around the brush, carefully snip the fibres with scissors, being careful not to damage the brush bar, pull away from the brush bar and dispose. 6 7 8 9 F 10 Re-fit dust canister into cleaner and push to lock into position. 11 Re-fit the front cover. G D www. morphyrichards. com 5 73332 rev1 17/10/07 10:40 Page 6 H SAFETY CUT-OUT If the cleaner overheats, a motor protection thermostat will automatically switch the motor off. [. . . ] Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. All Morphy Richards products are individually tested before leaving the factory. [. . . ]