User manual MORPHY RICHARDS FILTER RAPIDE KETTLE REV 1

[. . . ] · Do not touch hot surfaces, use handles or knobs. · Always close the lid securely, otherwise the kettle may not switch off automatically and may spit out boiling water. · Avoid contact with steam from the spout when the water is boiling or just after it has switched off. · Take care if opening the lid for re-filling when the kettle is hot. [. . . ] WARNING: This appliance must be earthed. Â 3 43545 Rev 1 21/3/05 2:57 PM Page 6 Using Filtering your water improves the taste and appearance of beverages by reducing limescale, lead, chlorine and other impurities. The amount of water must cover the kettle element. Do not fill above the maximum mark or filter performance will be impaired. Always ensure the kettle is emptied before refilling. Before use 1 Remove cartridge from the packet and place in a bowl of water and shake. 2 Take the top compartment (the cartridge holder) out of the kettle by pulling the cartridge holder lift tab Á forward and lift upwards. B 4 Insert the cartridge into the top compartment from the bottom and twist clockwise to lock in place. C 5 Replace the cartridge holder back into the kettle and click into place. Switching on You do not need to wait until the water has filtered through before switching on. Your Morphy Richards filter kettle, will boil and filter at the same time giving you boiled, filtered water quickly. · Boil only as much water as you need as this saves electricity. 1 Place the filter kettle on the base unit, ensuring the kettle locates on to the 360° connector. · The 360° connector allows the kettle to be located at any position, - ideal for left and right handed users and convenient positioning on worktop. 2 Plug in and switch on at the wall socket. The `power on' neon, will light up. 4 When the water boils the filter kettle will switch off automatically. · If you are using the kettle for the first time, discard the water and repeat once more. · To re-boil, switch to ON again. If the kettle has just switched off wait a minute or so before switching it back on again. · If you do not put in enough water, or switch on the filter kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. Filling the kettle 1 Fill the kettle with tap water to the maximum mark either by lifting up the lid D or by sliding the filler slider to one side as shown. E 2 Allow water to filter through system. When using for the first time, discard the water and repeat once more. A B C D E 4 43545 Rev 1 21/3/05 2:57 PM Page 1 5 Lift the filter kettle from the base unit by the handle ensuring you hold the kettle level. WARNING: Unless the cartridge holder is fitted correctly, the filter kettle may not operate correctly and the lid may not close and lock securely. Cleaning WARNING: Always disconnect the plug from the mains and allow the kettle to cool before cleaning. IMPORTANT: Do not use abrasive cleaners on the kettle which may scratch the surface. When to change your cartridge This depends on water quality and the improvement required. [. . . ] · This guarantee is valid in the UK and Ireland only. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. [. . . ]