User manual MORPHY RICHARDS FILTERMASTER III KETTLE

[. . . ] · Do not fill above the MAX mark, otherwise boiling water may be ejected. · Do not hold the switch in the on position or tamper with the switch to fix it in the on position as this may cause damage to the switch-off mechanism. · Unplug from the outlet before cleaning. · Allow to cool before putting on or taking off parts and before cleaning. Location · Always locate your kettle away from the edge of the worktop. [. . . ] · Always ensure that the level of water in the kettle is filled to at least the minimum level shown on the water gauge. Should your kettle not have a water gauge, always ensure that the element is covered. · Boil only as much water as you need as this saves electricity. 2 Place the kettle on the base unit, ensuring the kettle locates on to the 360° connector. · The 360° connector allows the kettle to be located at any position. - ideal for left and right handed users and convenient positioning on worktop. 3 Plug in and switch on at the wall socket. The `power on' neon, will light up. 5 When the water boils the kettle will switch off automatically. · If you are using the kettle for the first time, pour away the boiled water and refill. 6 Lift the kettle from the base unit by the handle ensuring you hold the kettle level. · To re-boil, switch to ON again. If the kettle has just switched off wait a minute or so before switching it back on again. · If you do not put in enough water, or switch on the kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. Filter removal 1 Open the lid. 2 Lift the filter upwards from its location using the tab provided. 3 To refit the filter, slot it into the side wall guides and press down firmly. Ensure the filter is correctly located into the central guide. WARNING: Unless the filter is fitted correctly, the kettle lid may not close and lock securely. 4 Filtermaster III Rev 2 14/8/03 4:56 pm Page 6 Descaling IMPORTANT: As this kettle is fitted with a concealed element it must be descaled regularly The frequency of descaling depends on usage and the hardness of the water in your area. Excessive scale can cause the kettle to switch off before boiling and may damage the element invalidating the warranty. It is essential that regular descaling takes place. Remove hard scale using a proprietary descaling product suitable for plastic kettles. [. . . ] · This guarantee is valid in the UK and Ireland only. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. [. . . ]