User manual MORPHY RICHARDS FLEECE WASHABLE HEATED UNDERBLANKET 75149

[. . . ] · Personal safety · WARNING: This appliance is not attended for use of persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the application by a person responsible for their safety. Do not use with a helpless person, an infant or a person insensitive to heat. Young children should be instructed on how to operate the controls safely and heat settings should be controlled by a parent or guardian. Children should be supervised to ensure that they do not play with the appliance. [. . . ] If you are in any doubt about your supply, ask your electrical dealer or local electricity company. SAFEGUARD OVERHEAT PROTECTION SYSTEM Activation The system will remain dormant indefinitely as long as the blanket is operating in the normal temperature range. If for any reason the blanket is operated in an abnormal situation or condition which would otherwise have induced a rapid temperature rise high enough to constitute a hazard the OVERHEAT SYSTEM should intervene by cutting off the supply current before the temperature reaches the point at which damage may occur. It is normal for the lead from the blanket to the switch to become warm as this is part of the heater protection circuit extended to the switch. In the event of the OVERHEAT SYSTEM operating, the blanket will cease to function. WARNING: Do not attempt to use the blanket with controls other than those supplied with the unit as referred to on the rating label attached to the blanket. Dual control models On double dual models users are able to control their own side of the bed with individual controls, tailoring independent temperatures to independent needs. Each side of the blanket has a completely separate element and each is supplied with its own independent mains lead. Do not connect both flexible cords to one 13amp plug. The two leads should preferably be plugged into individual sockets. However, if only one socket is accessible, then a muti adaptor should be used. WARNING: No attempt should be made to repair the blanket or have it repaired locally and the switch supplied must never be replaced since the specialised components are not generally available. The fact that this blanket incorporates the overheat system does not absolve the user from observing these instructions. WARNING: If you are unsure about electrical connections please contact a qualified engineer. It is quite normal for the switch to become warm as the components encased are part of the protection circuit. 4 UK Helpline 0870 060 2614 Ireland Helpline 1800 409119 75149 rev1 8/3/07 15:44 Page 5 Fitting the underblanket to the bed. · NOTE: This product can be used with any type of bedding including waterproof bed protectors. Use only as an underblanket and do not use above the occupant of the bed. The blanket must be secured to the mattress in the following manner. Place the blanket directly on the mattress and ensure that a space of 10-15cm (4-6 inches) is left between the bottom edge of the blanket and mattress. Place the underblanket directly onto the mattress. Making sure the control switch end is at the head of the bed, with the connector facing upwards. To accommodate for left and right hand use it is safe to reverse the blanket. Fitting instructions · · · Each blanket is fitted with 3 tie tapes. Position the blanket on the bed ensuring the pillow area is clear. Allow some `give' to avoid edge distortion. Ensure knots are not tied too tightly so that they can be undone easily. Pass the first tape / under the corner of the mattress. Pass under the adjacent corner and tie off to opposite loop. Repeat for second tape ¤ at opposite end of the blanket. Pass the centre tape < underneath the mattress and tie to opposite loop. [. . . ] of the appliance. 2 Disconnect the control switch and cord from the blanket by lifting the locking lever over the raised button and pull apart B. 3 Use a mild washing liquid or detergent and lukewarm water. 4 Immerse the blanket in the water and allow to soak for 5-10 minutes. 5 Squeeze the soapy water through the fabric. 6 Rinse the blanket thoroughly in cool water, gently squeezing the fabric. WARNING: Do not wring dry. UK Helpline 0870 0602614 Ireland Helpline 1800409089 After sales servicing Examine the blanket and cord frequently for signs of wear or damage. If the blanket fails to operate, check the following: 1 Ensure that the plug and socket have not become disconnected. 2 Check that the supply plug is correctly connected to the flex. 3 Check the supply fuse and the 3 amp plug fuse if applicable. 7 75149 rev1 8/3/07 15:44 Page 8 YOUR THREE YEAR GUARANTEE It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]