User manual MORPHY RICHARDS HARRY RAMSDEN S LARGE FAMILY FRYER 45076

[. . . ] 45076 rev1 22/3/07 08:52 Page 1 YOUR TWO YEAR GUARANTEE It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. [. . . ] Please note: Remove the filter from the lid before washing lid. Remove the oil storage container, ladle, frying basket, non stick oil tank, lid, body and wash these by hand in hot soapy water. Please note: do not leave in water to soak for a long period of time. WARNING: Do not immerse the control panel in water. Dry all parts of your fryer thoroughly and replace the oil tank, basket and lid. Replace the oil tank with the max/min lines to the rear. (Please follow the cleaning instructions). Removal of handles Rest the basket on a level, firm surface, press the handle down against the spring force and remove D. A Basket operation The handles are removable so they can be attached to the basket D. B Location of basket to drain With the lid open and in the vertical position, the basket can be raised into the rest draining position or removed completely E. When in the draining position the basket should be hooked on the basket rest lip (shown by the arrow). When lowering the basket back, lift up to remove from the basket rest position, push forward slightly and lower down. Press the basket release button and allow the handle to lower. When using the basket, both basket release buttons must be pressed to allow the basket to lower into the oil F. C D OPERATION Lid operation Press the lid release button, the lid is spring loaded and will rise up on its own A. In the upper position the lid will lift out of its guides at the back for easy cleaning. To replace, locate in the guides and slide back into position. Close the lid by pressing down in the centre and ensure locking catch , , is fully engaged B. Assembly/ Disassembly sequence The fryer has to be disassembled and assembled following this procedure. · · · · Open the lid and remove. Assembly is the reverse of the above process. F E Attaching the handle to a basket Rest the basket on a level, firm surface, locate the handle into the slots of the basket and pull upwards against the spring force C. 6 4 45076 rev1 22/3/07 08:52 Page 7 G Removal of the control panel 1 Lift up the fryer body at the front as shown and pull out the control panel G. Replace by locating the control panel in the guides and push fully in. Once the control panel is in place route the mains cable to the side or out of the back, whichever is convenient. 1 2 3 4 COOKING WARNING: Never operate the fryer without oil in the oil tank. Lower the basket (if required) and close the lid. [. . . ] 7 Dry all parts of your fryer thoroughly and reassemble all parts with the max and min at the back of the oil tank. Refer to the `Assembly Sequence' on page 4. The outside of the tank is not non-stick coated, if care is taken, it is unlikely to become dirty. If oil does drip down the exterior when the oil is being emptied out, make sure that it is hand washed thoroughly. [. . . ]