User manual MORPHY RICHARDS IB20012

[. . . ] (fig 1) 4 (fig 1) 5 3 For even cutting, allow the comb attachment cutter to cut its way through the hair. Comb hair frequently to remove trimmed hair and to check for uneven strands. 2 To remove the comb attachment 1 Lower the comb attachment to the lowest position. Hold the unit in your hand with the power switch facing the palm of your hand. With your thumb press upwards along the centre of the BEC" comb. [. . . ] With the trimming guide in place, set the guide to the desired setting. Slide the On/off switch to the `on' position and begin trimming. (figure 1) 2 To Recharge 1 2 3 4 Use only the adaptor (charger) provided. Connect plug to trimmer and plug adaptor into the electrical socket. When charging, the recharging indicator will light up showing correct recharging. 3 To trim outer edge of beard and add definition 1 Hold the trimmer diagonally with the front of trimmer facing away from you. Start at the chin and move back towards the ear. (figure 2) Follow the jawbone to cut away longer hairs on the outer edge of the beard. Attachment comb (trimming guide) Your male grooming system provides 1 adjustable attachment comb. Provides 5 settings of cutting length 2mm, 5mm, 8mm, 11mm and 14mm. Trim against the direction of the hair growth. Start at a longer setting (11mm or 14mm) to prevent accidentally trimming hair too short. As you become familiar with the setting, adjust the guide to the desired trimming length. 2 To define the beard line 1 2 Hold the trimmer vertically with the front of the trimmer facing you. Start with the trimmed edge of the beard and with a downward motion, trim the area directly under the beard line. 6 To thin and taper beard 1 2 Use the moustache comb to hold hairs in place while trimming. Hold the trimmer with front facing away from you. Trim hair ends using an upward motion. 3 Hold trimmer perpendicular as shown and move cutters sideways to achieve the desired line above the lip. (figure 4) To trim side burns To trim moustache (with trimming guide) 1 2 3 4 Ensure that the trimming guide is in place to avoid over trimming the hair. Comb hairs outward to the maximum height and in the same direction. Set the trimming guide to the desired setting. Hold the trimmer vertically with the front facing you and trim hairs using a downward motion following the direction of your hair growth or you may trim against your hair growth. 1 Comb side burns following the direction of your hair growth. Trim side burns using a downward motion. 2 Stubble look 1 Position trimmer guide to the 2mm setting and hold the trimmer horizontally with the front of the trimmer facing downwards or upwards. Trim hairs using a downward or upward motion following the direction of your hair growth. [. . . ] Please quote the model number if the product develops a fault. This number can be found on the handle of the product. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. [. . . ]