User manual MORPHY RICHARDS IB26010

[. . . ] Do not use this appliance with damaged or broken combs or with teeth missing from the blades as injury may occur. Switch off before fitting or removing attachments. Do not use this appliance near bathtubs, showers, basins or other vessels containing water. BATTERY DISPOSAL The batteries in this product are not replaceable. This product contains sealed nickel cadmium batteries. [. . . ] Blades must be realigned if they have been removed for cleaning or replacement. Ensure the AC power adaptor is not plugged into the clipper. To realign the blades, simply match the upper and bottom blades teeth up, point for point. If blade alignment is incorrect, add a few drops of oil to the blades, turn the clipper on for a few moments, turn off, loosen screws slightly and adjust. To maintain the clipper in peak condition, the blades should be oiled every few haircuts. Simply place a few drops of oil on the teeth of the blades. Due to the high speed of the clipper the correct oil must be used. Do not use hair oil, grease, oil mixed with kerosene or any other solvent. Solvent will evaporate and leave the oil thick, which may slow down the blades. Clipper oil is a very thin natural oil which will not evaporate and will not slow down the blades. THE AFTER SALES DIVISION Registered address: Morphy Richards Ltd. Mexborough, South Yorkshire S64 8AJ England Helpline (8:30-5:00 Mon-Thur/ 8:30-4:00 Fri) UK 0870 060 2614 Replacement parts 0870 167 6645, Republic of Ireland 1800 409119 Morphy Richards products are intended for household use only. Morphy Richards has a policy of continuous improvement in product quality and design. The Company, therefore, reserves the right to change the specification of its models at any time. Part number: PC26010M Rev 1 Imported by: Morphy Richards Ltd, Talbot Road, Mexborough, South Yorkshire S64 8AJ Thank you for buying your new Morphy Richards Mark Hill Clipper set. Please read these instructions carefully before use and keep in a safe place for future reference. ADJUSTABLE LEVER The lever is conveniently located near your thumb (if you are right handed), so that it can be easily adjusted while the clipper is in your hand. The lever adds versatility to your clipper by allowing you to gradually change the closeness of your cut without an attachment comb. When the lever is in the uppermost position, the blades will give you the closest cut and leave the hair very short. Pushing the lever downwards gradually increases the cutting length. To give your clipper extra power, press and hold the turbo button during use. KEY FEATURES 1. Includes: AC power adaptor, comb, scissors and oil 4. [. . . ] Comb the hair into its natural direction. Place the largest attachment comb onto your clipper and start by trimming the sides from the bottom upwards. Hold the clipper lightly against the hair with teeth of the attachment comb pointing up but flat against the head. Slowly lift the clipper up and outward through the hair, cutting only a small amount at a time. [. . . ]