User manual MORPHY RICHARDS IB27006

[. . . ] Important: This radio uses nickel-metal hydride rechargeable batteries. At the end of a nickel-metal hydride battery's useful life, it must be recycled or disposed of properly. The battery may be recharged up to 1000 times before needing to be replaced. Replacement rechargeable batteries may be purchased from our spares helpline on 0870 167 6645 (mon - Fri) CONNECTING POWER You can power your radio from any of these sources. [. . . ] Caution: The battery pack's polarized plug fits into the socket only one way. If the plug does not fit properly, turn it round and try again. 3 Set DYNAMO/BATT switch to DYNAMO or BATT. Charging takes place using either position. 4 Set On/Off/band selector switch to OFF. 5 Lift the crank handle and rotate it clockwise or counterclockwise. Radio operation time depends on the number of turns and the time per turn. For example, approximately 2 turns per second for 90 seconds will provide about 30 minutes of radio operation at a medium volume level. You can recharge the battery pack even while the radio plays. 6 Return the crank to the folded position. Replace the Ni-MH battery when the play time reduces to an unacceptable level. 2 Unplug the rechargeable battery pack connector and lift the pack out of the compartment. !Insert a new battery pack plug into the socket and place the battery into the compartment. Caution:The supplied battery pack plug has the red wire toward the top of the radio when inserted correctly. To ensure proper polarity, only use the supplied or recommended replacement battery pack. OPERATION PLAYING THE RADIO 1 Rotate DYNAMO/BATT switch to BATT if you have installed AA batteries. To power the radio using the Ni-MH pack or the generator, rotate DYNAMO/BATT switch to DYNAMO. 2 Set On/Off/band selector switch to the desired band. 3 Rotate TUNING control to select the desired station. 4 Adjust VOLUME control to a comfortable listening level. [. . . ] Use of detergents may damage the finish. 5 6 Specifications Guarantee BANDS Frequency Range Intermediate Frequency GENERAL Power Output Power Requirement Headphone Impedance Speaker Aerial Dimensions (HxWxD) Weight (without batteries) MW 522 - 1620 kHz FM 87. 5 - 108 MHz MW 465 kHz FM 10. 7 MHz 80 mW (maximum) DC 3V (2 batteries UM-3/ AA) DC 2. 4V 1 rechargeable battery 8 Ohm 45 mm Ferrite Bar aerial for MW Telescopic aerial for FM 3 3/4 x 7 1/2 x 2 3/8 inches 96 x 190 x 61 mm 1 lb 5 oz (600 g) Morphy Richards products are manufactured to internationally accepted quality standards. In addition to your statutory rights, Morphy Richards guarantee your product to be free from manufacturing and component defects for a period of TWO YEARS from date of purchase. If your product proves to be defective within 28 days of purchase, your Morphy Richards dealer from whom the product was purchased will be pleased to replace it free of charge. Should your product develop a defect within the guarantee period but after the replacement period, please return the product to the following address, together with the proof of purchase, brief details of the symptoms and your own name and address. [. . . ]