User manual MORPHY RICHARDS IB27007

[. . . ] Important: This radio uses nickel-metal hydride rechargeable batteries. At the end of a nickel-metal hydride batterys useful life, it must be recycled or disposed of properly. The battery may be recharged up to 1000 times before needing to be replaced. Replacement rechargeable Ni-MH batteries may be purchased from our spares helpline on: 0870 167 6645 (Mon-Fri) When using your radio in Europe the BBC World Service can be heard on the following wavebands and frequencies:WAVEBAND FREQUENCY IN MEGAHERTZ (MHz) SW1 6. 180 6. 195 SW2 7. 115 7. 120 7. 150 7. 325 SW3 9. 410 SW4 11. 780 11. 785 SW5 15. 485 15. 575 SW6 17. 640 17. 705 IMPORTANT Not all the frequencies will be audible in all parts of Europe, the listener should try each frequency in turn as some are not used all the time and can change according to atmospheric conditions or because of interference. CONNECTING POWER You can power your radio from any of these sources. [. . . ] If the plug does not fit properly, turn it round and try again. 3 Set DYNAMO/BATT switch to DYNAMO or BATT. Charging takes place using either position. 5 Lift the crank handle and rotate it clockwise or counterclockwise. Radio operation time depends on the number of turns and the time per turn. For example, approximately 2 turns per second for 2 minutes will provide about 30 minutes of radio operation at a medium volume level. You can recharge the battery pack even while the radio plays. 6 Return the crank to the folded position. Replace the Ni-MH battery when the play time reduces to an unacceptable level. 2 Unplug the rechargeable battery pack connector and lift the pack out of the compartment. 3 Insert a new battery pack plug into the socket and place the battery into the compartment. Caution:The supplied battery pack plug has the red wire toward the top of the radio when inserted correctly. To ensure proper polarity, only use the supplied or recommended replacement battery pack. OPERATION PLAYING THE RADIO 1 Rotate DYNAMO/BATT switch to BATT if you have installed AA batteries. To power the radio using the Ni-MH pack with the generator, rotate DYNAMO/BATT switch to DYNAMO. 2 Set band selector FM/MW/LW/SW switch to the desired band. 3 Rotate TUNING control to select the desired station. 4 Adjust VOLUME control to a comfortable listening level. 5 To turn off the radio, set VOLUME/ON/OFF switch to OFF. Using the display light Hold down LIGHT to illuminate the dial in low-light conditions. Using the emergency alarm Press the EMERGENCY ALARM button. The radio sounds a loud, repeating beep. Press EMERGENCY ALARM button again to stop the alarm. [. . . ] If you need any further advice, please call our Helpline on: 0870 060 2614 (Mon-Fri) Morphy Richards Website: www. morphyrichards. co. uk GENERAL Power Output Power Requirement Headphone Impedance Speaker Aerial Maintenance Do not expose your radio to extremes of temperature. The product should be kept in a warm environment free from dust and damp. For external cleaning use only a soft, clean, damp cloth. Use of detergents may damage the finish. WARNINGS Do not expose this unit to direct sunlight or heat radiating sources. [. . . ]