User manual MORPHY RICHARDS IB28023

[. . . ] By holding the hour button down, the hour will advance by 5 hours. Battery back-up facility (unit will work without batteries being fitted) Your alarm clock is equipped with a battery back-up facility. 1 2 3 Remove the battery compartment cover (located underneath the unit) by pushing in the clip and lifting off. Insert 3 x AA size 1. 5V batteries and connect to terminals (Ensure the batteries are inserted correctly). (Batteries not supplied). 4 Note : In this mode, the unit will not be able to receive the automatic MSF signal. Setting the alarm 1 time 1 2 Press the ALARM button (6) once in time mode. As the alarm button is released the previous alarm time will display. [. . . ] 2 Press and hold the TIME button for 3 seconds in time mode, the current year is displayed. Press the SNOOZE button twice to review the day of the week, the day will appear on the display, dAY1 . . . dAY7 will be displayed which stands for Monday to Sunday respectively. The day of the week cannot be changed but it is already set according to the date. Press the TIME button to return to time mode. If you do not press any buttons for 15 seconds the clock will return to time mode. Viewing the previous alarm type 1 2 Press the ALARM button to select the setting for alarm 1 or alarm 2. Press and hold the SNOOZE button, the previous alarm type displays. Note : Do not press the SNOOZE button again, otherwise, the type of alarm will be changed. Press the TIME button, to exit the alarm setting mode. (The alarm mode will also exit if no buttons are pressed for 15 seconds). 3 MSF Signal 1 2 This mode starts when the HOUR/MSF has been pressed in time mode, `-0 0-` displays. If you want to review the current time when receiving MSF signal, press the TIME button. Press the HOUR/MSF to alternate between MSF on mode and off. When the MSF signal is detected the two digit counter will count up steadily from 00 to 59, until the clock is synchronised. Note : If the two digit counter is not counting up, then it is not receiving the MSF signal, change the position of the unit for the best reception. When the TIME button is pressed or when a valid MSF signal has been received the clock will return to time mode. The unit will automatically synchronize at 12. 00am and 3. 00am everyday. 3 Reviewing / setting the year 1 2 3 4 Press and hold the TIME button for 3 seconds in time mode, the current year will be displayed. Press the MINUTE button once to change the year in the following sequence: 1999-2000 - . . . - 1999 - 2000 Press the HOUR/MSF to change the setting by 10 years. If an incorrect date is entered after advancing the year by one, like Feb 29th 2001, the date will be set to the maximum day of that month, which is 28th Feb 2001 automatically. Press the TIME button to return to time mode. If you do not press any buttons for 15 seconds the clock will return to time mode. 3 4 5 6 5 To stop the alarm tone (Alarm 1 and 2 have individual alarm tones). The alarm is programmed to run for 59 minutes. 1 To stop the alarm, press the ALARM button (6). [. . . ] ATTENTION: To reduce the risk of electric shock, do not remove the cover. There are no user serviceable parts inside the unit. Refer any servicing to qualified personnel. The lightning flash with arrowhead symbol within the triangle is a warning sign alerting the user of `dangerous voltage' inside the unit. [. . . ]