User manual MORPHY RICHARDS IB4060X

[. . . ] Comfi-grip iron steam/spray/shot Please read and keep these instructions getting the best from your new iron. . . · Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. · Jet cleaning Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing. www. morphyrichards. co. uk Important safety instructions The use of any electrical appliance requires the following common sense safety rules. Primarily there is danger of injury or death and secondly the danger of damage to the appliance. These are indicated in the text by the following two conventions: WARNING: Danger to the person! [. . . ] Set the temperature control dial B to the temperature required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light , , which will go on and off while you are ironing. B 4 This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. higher steam C lower steam Features of your iron Temperature indicator light The indicator light shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. Dry ironing You can use your iron as a dry iron only. Make sure the variable steam control / is set to the `0' symbol. Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. Spray Press the spray button < and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Variable steam Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be varied from low to high by sliding the variable steam control C. When using the iron at the bottom of the steam range, the steam output should be adjusted to the lowest setting. The steam facility should only be used on garments which are suitable for ironing at 2 and 3 dot setting. Shot of steam Press the shot of steam button ¤ to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range shown on the control. Note: For optimum steam quality, do not operate the shot more than three times in succession. [. . . ] Wait for the temperature indicator light to go out, then unplug the iron and hold it about 6'' (150mm) above the sink in the ironing position. Press the shot of steam button about 10 times in succession. 7 Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]