User manual MORPHY RICHARDS IB40620

[. . . ] Let the iron cool completely before putting away. Loop the cord loosely around the iron before storing. 7 Always disconnect the iron from the electrical socket when filling with water or emptying, and when not in use. 9 Do not operate the iron with a damaged cord or if the iron has been dropped or damaged. [. . . ] If you wait a few minutes, the iron will stabilise at the required setting. MAX Before use Note : The steam facility should only be used on garments which are suitable for ironing at the 2 dot, 3 dot and MAX setting. Textiles and clothes are supposed to carry ironing instructions. If they don't you should follow the fabric guide on the rear of the iron, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the temperature down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 4 · To indicate that the iron is heating up arrow above the thermometer symbol will flash. · To indicate that the iron is cooling down the arrow below the thermometer will flash. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. DIGITAL SYEAM 4 13/8/02, 12:29 PM · When your iron reaches the correct temperature for the first time it will beep twice. The arrow icon will also stop flashing to show that the iron has reached the correct temperature. To adjust the temperature setting depress the a beep will be audible FUNCTION button every time the function button is pressed. The temperature will cycle up and down (MAX - 3 dot - 2 dot - 1 dot - 2 dot. . . etc) and will be indicated on the LCD display. Variable Steam Fill the iron with water as described in "Filling", page 4 and insert the plug into the electrical socket. Press the function button until the 2-dot, 3-dot or MAX setting is displayed (as required) and rest the iron on it's heel whilst it warms up. The heating up arrow icon will disappear when the iron is at the correct temperature. to give the Turn the variable steam control desired amount of steam . The steam facility should only be used on garments which are suitable for ironing at the 2 dot, 3-dot or MAX setting. High Low Off It is always a good idea to begin with `cool' fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Shot of steam Press the shot of steam button to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set to the steam position. Do not use shot of steam at temperatures below 2-dot. Note : For optimum steam quality, do not operate the shot more than three times in succession. Features of your iron Dry ironing You can use your iron as a dry iron only. Make is set to the sure the variable steam control "0" symbol. Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. Vertical steam Hold the iron in a vertical position between 1 cm and 2 cm away from the item. Press the shot of steam button, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. Spray Press the spray button and aim the spray of water at stubborn creases. [. . . ] · This guarantee is valid in the UK and Ireland only. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. [. . . ]