User manual MORPHY RICHARDS IB40713

[. . . ] Is the plug itself or the socket faulty?(Check by plugging in another appliance). · WARNING: When not in use, your iron should never be placed flat and left on an ironing board. · To prevent damage to the textile being ironed, follow the temperature guide carefully. [. . . ] A > fi fl · , , / ¤ < > fi fl · , , , Variable steam button Shot of steam button Spray button Filling hole with cap Spray nozzle Soleplate Temperature console Water tank Life long anti-scale (certain models only) Filling beaker Auto shut-off indicator Before use Note: The steam facility should only be used on garments which are suitable for ironing at the 2, 3 dot settings. When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section). Textiles and clothes are supposed to carry ironing instructions. If they don't you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you adjust the temperature from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 4 40715 Rev 1 31/5/05 9:11 AM Page 5 Temperature control B Increase temperature Decrease temperature Spray Press the spray button < and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Variable steam Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be varied from low to high by turning the variable steam control C. When using the iron at the bottom of the steam range, the steam output should be adjusted to the low setting. The steam facility should only be used on garments which are suitable for ironing at 2, 3 dot and MAX setting. C Steam off · Default setting + 3 dot (cotton) · To increase temperature press the top button. · To decrease temperature press the bottom button. · The light panel will flash to indicate that the iron has not yet reached the correct temperature. · Once the correct temperature has been reached , the light will stop flashing and there will be one `beep' to signal that the iron is now ready for use. Features of your iron Dry ironing You can use your iron as a dry iron only. Make sure the variable steam control / is set to the `0' symbol. Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. `MAX' steam 5 40715 Rev 1 31/5/05 9:11 AM Page 6 Shot of steam Press the shot of steam button ¤ to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range shown on the control dial. Note: For optimum steam quality, do not operate the shot more than three times in succession. [. . . ] · Name of the product · Model number as shown on the underside of the appliance. Emptying and storing When you have finished ironing, unplug your iron. Ensure that the variable steam control is set at the `0' position, lift up the fill cap and empty any remaining water out of the filling hole. 7 40715 Rev 1 31/5/05 9:11 AM Page 8 Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]