User manual MORPHY RICHARDS IB421XX

[. . . ] 6 Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. [. . . ] 4 When ironing is complete, remove the plug from the socket, empty any remaining water from the tank, and allow to cool before storage. 5 If you drop or severely knock your iron this could cause internal damage even if the outside appears alright. Have it checked by a qualified electrician. 6 It is recommended that you use up one beaker of water by operating your iron's steam and shot of steam functions before ironing any clothes as some dripping may occur while your iron's steam system is activated. SAVE THESE INSTRUCTIONS 2 Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted. IMP0RTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED, MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET. Should the fuse in the 13 amp plug require replacement, a 13 amp BS1362 fuse must be fitted. WARNING : THIS APPLIANCE MUST BE EARTHED. Instructions for use Temperature guide Heat setting markings on the adjustable control dial of all Morphy Richards irons match those of the international Textile Care Labelling Code. Symbol (120 C Max) Cool Control knob positions Fabric o (160 C Max) Warm o (210 C Max) Hot o Do not iron at all Nylon, Acetates e. g. Acrilan Courtelle, Orlon Triacetates, e. g. If moisture required use damp cloth (Not Acetate) Dry and spray Dry ironing Wool, polyester mixtures e. g. Polyester/Cotton Cotton, linen Rayon, Rayon mixtures, e. g. Rayon/Linen Fabrics requiring this setting usually require steam pressing for heavy cotton, denim etc Steam/spray/ shot of steam Ironing With water in tank Without water in tank 3 Components of your iron Filling 1 Make sure that the iron is not plugged in and then set the variable steam control to the "0" position before filling the iron with water. 2 Fill the water through the filling hole into the water tank , using the beaker provided. In hard water areas the use of distilled or demineralised water is recommended. Never use battery topping-up fluid or water containing any substances like starch or sugar, or defrosted water from a refrigerator. 3 Always pour out the remaining water after use. WARNING : When filling your iron with tap water always use the beaker provided. Never fill directly under the tap. Spray button Shot of steam button Variable steam control Filling hole Spray nozzle Soleplate Temperature control dial Water tank Temperature indicator light and dial pointer Temperature control Plug in the iron and switch on. Set the to the temperature temperature control dial required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with `cool' fabrics and work up to higher settings. [. . . ] Place the iron on a flat surface in a standing position. Turn the temperature dial in a clockwise direction to the maximum setting. When the temperature indicator light goes off for the second time, turn the temperature dial in an anticlockwise direction to `min'. Disconnect the iron from the mains outlet and hold the iron horizontally over a sink. [. . . ]