User manual MORPHY RICHARDS IB47004

[. . . ] 47004 Rev 1 22/7/03 5:39 pm Page 1 Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. [. . . ] While the coffee maker is switched ON the hot plate will keep the coffee warm. 10 Switch off the coffee maker when the jug is empty or the coffee is no longer required. WARNING: The coffee maker and hot plates are hot and remain hot for some time after switching off. 12 Remove the permanent mesh filter and empty the used coffee grounds. Wash the filter immediately and dry thoroughly. NOTE: THE MESH WILL BECOME DISCOLOURED AFTER A WHILE DUE TO THE STAINING EFFECT OF COFFEE. Refilling 3 Spoon the required amount of ground filter coffee into the mesh filter spreading it evenly. We suggest one level measuring spoon for every cup. Ensure the filter is sitting properly in the filter holder. 5 Select the strength of coffee required using the strength selector on the reservoir lid. 1 Switch off the coffee maker and allow 5 minutes to cool before refilling with cold water. 5 47004 Rev 1 22/7/03 5:39 pm Page 7 Locating the filter 1 To remove the filter, slide the locking tab on the removable filter holder to the unlock position and and lift both the holder and mesh filter out to clean. (see cleaning) measuring spoon provided. Special marks on the inside of the filter show the correct levels for 2, 4 and 6 cups of coffee. Using the flat end of the spoon lightly compress the coffee down. Remove excess coffee from the edge of the filter. Locking tab Rib 2 To refit, place the removable filter holder into the top of your coffee maker, making sure the tab lines up with the rib then slide the locking tab to the lock position. Place the permanent mesh filter inside the filter holder by lining up the locating tab with the groove in the filter holder as shown. 5 Position the filter holder underneath the water outlet Ò, push it upwards and turn it to the right into the locked position to fix it onto your coffee machine. Note : Push firmly to the right to lock into position. 6 Your machine is fitted with a strength selector Î which allows you to make LIGHT to STRONG coffee. Use your glass jug for measuring the correct amount of water needed. Follow steps 1-11 how to make a perfect espresso. Push and release the milk frother button. When the milk is frothy, (which normally takes around 30 seconds), press the milk frother button once more to stop the frother. 4 Pour the coffee into cups and gently pour or preferably spoon the milk onto the coffee, then sprinkle a little chocolate powder for perfect cappuccino. Turn off the milk frother hot plate by pressing the neon on/off switch. [. . . ] Care must be taken to ensure that nondrip valve situated on the bottom of the filter holder is not damaged during cleaning. Espresso Unplug the coffee maker, slowly remove the pressure cap and allow to cool. Do not immerse the coffee maker in liquid. Rinse the water tank occasionally with cold water. Do not use a cloth as any residue or lint may be left behind to clog the coffee maker. [. . . ]