User manual MORPHY RICHARDS IB47012

[. . . ] · Do not use the coffee maker outdoors or in a bathroom. · Do not place the coffee maker on a highly polished wooden surface as damage may occur to the surface. · Do not place the coffee maker on or near hot surfaces such as a hot plate or radiant rings or near a naked flame. · WARNING: Do not place the coffee maker onto a metal tray or metal surface whilst in use. Product safety · Never use warm or hot water to fill the water reservoir. [. . . ] 8 Hot water will start to flow through the coffee grounds and into the glass jug as coffee. 9 When the coffee has been made, the green ready light will glow. The anti-drip valve will prevent any remaining coffee dripping onto the hot plate. Ensure that the jug is replaced on the hot plate after serving. While the coffee maker is switched ON the hot plate will keep the coffee warm. 10 Switch off the coffee maker when the jug is empty or the coffee is no longer required. WARNING: The coffee maker and hot plate are hot and remain hot for some time after switching off. 12 Remove the permanent mesh filter and empty the used coffee grounds. Wash the filter immediately and dry thoroughly. NOTE: THE MESH WILL BECOME DISCOLOURED AFTER A WHILE DUE TO THE STAINING EFFECT OF COFFEE. NOTE: IT IS NORMAL FOR THE GREEN READY LIGHT TO GO OUT AND COME BACK ON INTERMITTENTLY DUE TO THERMOSTATIC CYCLING. Refilling 1 Switch off the coffee maker and allow 3 minutes to cool before refilling with cold water. 4 47001 Rev 2 3/2/04 3:34 pm Page 5 Locating the filter 1 To remove the filter, slide the locking tab on the removable filter holder to the unlock position and and lift both the holder and mesh filter out to clean. (see cleaning) 2 To refit, place the removable filter holder into the top of your coffee maker, making sure the tab lines up with the rib then slide the locking tab to the lock position. Then place the permanent mesh filter inside the filter holder by lining up the locating tab with the groove in the filter holder as shown. Cleaning care Unplug the coffee maker and allow to cool. Do not immerse the coffee maker in liquid. Rinse the water reservoir occasionally with cold water. Do not use a cloth as any residue or lint may be left behind to clog the coffee maker. Remove the permanent filter, discard used coffee and wash. Extended soaking helps to remove coffee stains from the mesh. Wash the glass jug, jug lid, and filter holder in warm soapy water. Wipe all external surfaces including the warming plate with a damp cloth and dry thoroughly. Care must be taken to ensure that nondrip valve situated on the bottom of the filter holder is not damaged during cleaning. NO PARTS ARE SUITABLE FOR CLEANING IN A DISHWASHER. Locking tab Rib Descaling · If you live in a hard water area, we recommend that your coffee maker is descaled at regular intervals, e. g. [. . . ] · This guarantee is valid in the UK and Ireland only. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. [. . . ]