User manual MORPHY RICHARDS IB47470

[. . . ] 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters and glass jugs for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. All Morphy Richards Products are individually tested before leaving the factory. [. . . ] 14 The use of attachments or tools not recommended or sold by Morphy Richards may cause fire, electric shock or injury. 15 Do not use abrasive cleaners on the outside of the coffee maker, they may scratch the surface. 16 Do not use the coffee maker for other than its intended use. 17 Do not use the coffee maker outdoors or in a bathroom. 18 Do not place the coffee maker or glass jug on a highly polished wooden surface as damage may occur to the surface. 19 Do not use the glass jug in a microwave. 20 Do not place the coffee maker on or near hot surfaces such as a hot plate or radiant rings or near a naked flame. Warning: Do not place the coffee maker onto a metal tray or metal surface whilst in use. SAVE THESE INSTRUCTIONS 2 2 Electrical requirements Features Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. WARNING: The plug removed from the mains lead, if severed, must be destroyed as a plug with bared flexible cord is hazardous if engaged into a live socket outlet. WARNING: THIS APPLIANCE MUST BE EARTHED Should the fuse in the 13 amp plug require replacement, a BS1362 13 amp fuse must be fitted. Hinged reservoir lid with strength selector Removable permanent mesh filter Removable filter holder Non-drip valve Jug lid Glass jug with water level indicator Hot plate Water level indicator Neon on/off switch The first time you use your coffee maker Before using your coffee maker the first time, operate the coffee maker with water only. 3 General use 1 Lift up the hinged reservoir lid. 2 Fill the glass jug with the required amount of cold water and pour into the reservoir. Both the jug and water level indicator are marked in cups. Do not exceed the maximum level. 6 Slide the jug into the coffee maker ensuring it sits correctly on the hot plate. The jug lid must be in place during the brewing process, otherwise the non-drip valve will not open, causing the filter to flood. 7 Plug the coffee maker in at the wall socket and switch the coffee maker ON. The switch will light up to show the coffee maker is working. 8 Hot water will start to flow through the coffee grounds and into the glass jug as coffee. 9 When the coffee has been made, serve as required. The anti-drip valve will prevent any remaining coffee dripping onto the hot plate. Ensure that the jug is replaced on the hotplate after serving. [. . . ] Don't use a cloth as any residue or lint may be left behind to clog the coffee maker. Remove the permanent filter, discard used coffee and wash. Extended soaking helps to remove coffee stains from the mesh. Wash the glass jug, jug lid and filter holder in warm soapy water. [. . . ]