User manual MORPHY RICHARDS IB47570

[. . . ] · Do not lift the coffee maker by gripping the water tank. Hold the body of the coffee maker. · When unplugging, turn any control to `off', then remove plug from the wall outlet. · Keep the outside of the coffee maker area clean and dry at all times. · Do not immerse the coffee maker itself in water and always ensure the electrical connections are kept dry. [. . . ] 8 Once the cups are filled to the desired level press the coffee selector button. Water will still filter through for a few seconds after the machine has been switched off. WARNING: Never remove the filter holder when water is running through it. 9 Remove the filter holder and filter by turning the filter holder handle to the left. 10To the remove the used coffee grounds from the filter, turn the filter holder upside down. I I J IMPORTANT: For the froth enhancing attachment to work you must ensure that it is pushed firmly onto the steam nozzle. 2 Fill the water tank with cold tap water. The `power light' and `warm up light' will both illuminate. 4 Swing the steam nozzle with the froth attachment to the side of the machine. Use approximately 100ml for each cappuccino. Note: For best results we recommend to use refridgerated milk and a stainless steel jug that is well chilled. The steam ligth È will illuminate and stay lit whilst the unit is in steam mode. 7 When the unit is the right temperature the `warm up light' will go out. 8 Hold the jug under the steam nozzle so that the head of the froth attachment is immersed in the milk. K K 11Once the orange `warm up light' goes out your machine is ready to make the next espresso. Steam function The froth attachment makes it easy to produce frothy milk for cappuccino. 1 Attach the froth attachment to the end of the steam nozzle. J 9 Turn the steam control dial towards the steam symbol . You will hear the machine make a pumping noise, this is normal. IMPORTANT: Do not allow the tip of the nozzle to touch the bottom of the jug because this could obstruct the passage of steam. 10Once the froth has been produced, turn the steam control dial towards and remove the jug. Note: Do not be alarmed by the escaping steam from the base. 11The milk is ready as soon as it forms a thick layer of foam on the top. [. . . ] Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced. [. . . ]