User manual MORPHY RICHARDS IB70222

[. . . ] 7832 3-in-1 ib 11/07/2003 14:26 Page 1 3-in-1 cleaning system Please read and keep these instructions getting the best from your new 3-in-1. . . If your cleaner isn't performing as well as it should, please check · Dustbags It is important to replace them, otherwise the performance of the cleaner will be impaired · Filters It is important that the cartridge and foam filters are cleaned regularly or replaced to allow air through the appliance · Blockages Check the nozzle, tubes and hose for blockages www. morphyrichards. co. uk 7832 3-in-1 ib 11/07/2003 14:26 Page 2 Important safety instructions The use of any electrical appliance requires the following of common sense safety rules. Primarily there is danger of personal injury and secondly danger of damage to the appliance and property. These are indicated in the instructions text by the following two conventions: WARNING: Danger of personal injury IMPORTANT: Damage to the appliance In addition we offer the following essential safety advice. · · Never use in the presence of explosive liquids or vapours. Never pick up hot or glowing ash, hot cigarette ends, hot coals or any other similar items. Other safety considerations · · Never use the appliance without the filter installed. [. . . ] The filter can then be removed and cleaned by either gently tapping or rinsing in water. Once dry, the filter can be put back in the exhaust filter holder. This can then be replaced by first locating the bottom into position, and then pushing the top firmly until it clicks into position. Ensure that the exhaust filter holder has been fitted securely otherwise it may come off during use. Dust collection bags When collecting dry material, your cleaner can be used with or without a paper dust collection bag. Using a bag makes for easier collection and disposal and should be fitted as shown H. With the hose end removed, slide the cardboard collar on the collection bag into the slots inside the waste tank and push the bag so that it fits around the outside of the tank. Bend the top of the cardboard collar back along the crease to allow easy fitment of the motor housing. Refit the hose end and then the motor housing. There is no need to remove the cartridge filter. · Do not use a bag for picking up nails, broken glass or other sharp objects as these may cause it to tear. · Do not use a bag for wet pick up. · Dust collection bags cannot be used when the bucket is fitted inside the tank. 8 7832 3-in-1 ib 11/07/2003 14:26 Page 9 Cable storage When not in use, the cable can be stored by wrapping it around the section above the exhaust filter flap and the cable storage hook at the back of the cleaner J. Automatic cable rewind (if fitted) Reel out the cable to its full length. After use, unplug and press the release button on the handle E 3. 9 7832 3-in-1 ib 11/07/2003 14:26 Page 10 K ~ L ¯ ^ Û Ù i N & % Û * ) ( 7832 3-in-1 ib 11/07/2003 14:26 Page 11 M Ò O P R @ S ° 7832 3-in-1 ib 11/07/2003 14:26 Page 12 Shampooing instructions Features In addition to the components previously mentioned under the `Wet & Dry' section, the following will be used when shampooing: Foam filter Ò Foam filter locking plate Ú Clean water tank Ù Filler cap i Filter ^ Feed pipe ~ Cleaning solution ¯ Water inlet Trigger % Shampoo tube & Clips ( Shampoo nozzle ) Tube connector * Shampoo jet @ Upholstery nozzle (optional) ° Hard floor shampoo attachment (optional) underneath the motor housing (see `Cartridge Filter' in the Wet & Dry section). IMPORTANT: The foam filter must always be fitted when you are shampooing. The filter should be pushed up against the base of the motor housing and secured by use of the foam filter locking plate. The locking plate is inserted beneath the foam filter and rotated clockwise until it locks into position M. Push the trigger so that it clips onto the curved handle and then attach the special clip with the shampoo tube connected to the upper extension tube N. Fit the shampoo nozzle to the extension tubes. Attach the tube connector to the shampoo jet on the front of the cleaner. Connect the other end of the shampoo tube to the nozzle on the back of the shampoo nozzle. 6 Squeeze the trigger towards the curved handle whilst slowly moving the shampoo nozzle backwards. Upholstery shampoo nozzle The optional upholstery shampoo nozzle is available as an accessory and is ideal for cleaning sofas, chairs, stairs and car interiors. It is attached directly onto the end of the curved fitting and the shampoo tube from the trigger is fixed directly onto the nozzle at the back in the same way as the floor nozzle R. Shampooing hard floors Hard floors such as tiles, stone, etc. [. . . ] Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. · If for any reason this item is replaced during the two-year guarantee period, the guarantee on the new item will be calculated from original purchase date. [. . . ]