User manual MORPHY RICHARDS IB70515

[. . . ] 70515+70516 Rev 1 19/5/04 3:59 PM Page 1 GrimeBuster steam cleaner Please read and keep these instructions getting the best from your new cleaner. . . Please study all instructions carefully before use. This product is also supplied with a user guide CD ROM. No steam · Check the power supply. · Check the steam switch is set to the on position. WARNING: If the cleaner has been boiled dry it must be switched off for a few minutes to allow the safety cut-out to reset. [. . . ] 2 Make sure that the locking mechanism Á on the handle has been released. If you push the lock Á towards the rear, the steam switch cannot be operated. Push the lock forward so that the steam switch is released. G 3 To make steam ready, press the `steam on/off' button < and the orange light · will come on. 4 To release steam, press the handle control switch Ê. At the start, always point the steam handle at a cloth until a steady flow of steam comes out. · During steam release the green heater light will turn off. 5 To stop releasing steam, simply release the handle control switch Ê. Operating your steam cleaner 1 Connect the unit to the mains and switch on the boiler heater by pressing the heater on/off button ¤. The `heater on light' is illuminated. Certain models only · If your cleaner features a vari-steam knob Í the steam flow can be adjusted to specific requirements. 6 Turn the vari-steam knob fully anticlockwise for maximum steam and clockwise for minimum steam flow H. · If the `refill' indicator light turns red, the boiler must be refilled. E G Á Ê Â F H Í 5 70515+70516 Rev 1 19/5/04 3:59 PM Page 6 Re-filling When the `refill' light turns red, there should be no steam available for release. 1 Switch off the boiler heater by pressing the heater on/off button ¤. 2 If there is pressure in the boiler, the filler cap / will revolve, a safety feature prevents it from being unscrewed. 3 Release any steam pressure in the system using the steam on/off switch < on the machine and handle Ê. Switch off the steam release button <. Leave the product with the filler cap off for 10 minutes before refilling. 6 Use warm water to reduce heat-up time. WARNING: Do not pour cold water into a very hot boiler as steam and hot water may be blown out of the filling hole and can scald. (See operation section). Use of accessories Steam handle  To avoid spurting of heavy and moist steam it is recommended always to attach an accessory to the steam handle. Large floor brush Ì Recommended applications include: - carpets and rugs - sealed timber and parquetry - ceramic tiles - vinyl 1 The large floor brush can be attached to the extension tubes or directly to the steam handle, provided that the brush connector Ó is fitted. 2 Stretch the cotton cloth lightly over the bristles using the clips provided on the brush head I. 3 Switch on the steam and move the cloth covered brush gently over the surfaces to be cleaned. [. . . ] Safety lock on hose handle engaged. Solution Check the fuse, plug and socket. Disengage the safety lock. Very little steam Variable steam controller not open. (Some models only) Adjust steam controller knob. Very long heat up time. Loud whistling noise accompanied by steam from the rear of the machine. Limescale build-up inside boiler. Descale. If you encounter any other problems with the product, contact our Morphy Richards helpline. 9 70515+70516 Rev 1 19/5/04 3:59 PM Page 10 Two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. [. . . ]