User manual MORPHY RICHARDS IB73091

[. . . ] Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. Use only genuine Morphy Richards spare parts and accessories Location · · Do not use or keep this product outside when it is raining. Do not store the appliance near hot ovens or heating appliances. Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. [. . . ] 2 Remove the floor nozzle by pressing in the release button Ï and pulling the floor nozzle away from the body H. 3 Slide the hose end Ë from the hose end location Á. I 4 Fit the extension tube to the hose end Ë. 5 Fit the crevice tool Ò to the extension tube. 6 If required fit the brush Ú to the end of the crevice tool 7 Press the switch to position I . Attachments Uses for the brush attachment include stairs, upholstery, mattresses, curtains and hard surfaces like door mouldings and skirting boards. The crevice tool is particularly useful for cobwebs and in narrow gaps in the car around the handbrake and seat. H J I K 5 73091 Rev 3 15/6/05 9:18 AM Page 6 4 Using the handle, pull the filter assembly from the top of the dust pod. L 5 Empty the dust pod and put safely to one side. 6 Remove outer filter, using lever action as opposed to straight pull, empty out any dust. M 7 Refit outer filter by pushing gently onto three lugs. Locate rear of the filter assembly first. Note: All parts of the dust pod and dust pod filter assembly are washable. IMPORTANT: All parts must be fully dry before re-fitting. Replacing dust container 1 Insert the hook at the bottom rear of the dust pod into the tray on the body. 2 Push the dust pod towards the cleaner body until it clicks into place. Exhaust filter After approximately 5 emptyings of the dust container the exhaust filter should be cleaned. 1 Unclip the exhaust filter cover È by lifting the bottom tab. 3 Shake the filter vigorously to remove any build up of dust. 4 Refit exhaust filter cover by inserting top two pegs then clip in the bottom tab. Depending on usage, the exhaust filter should be replaced approximately every 6 months. L M O N P 6 73091 Rev 3 15/6/05 9:18 AM Page 7 Cleaning the machine Use the brush attachment on the hose and use the Pod to vacuum itself. To keep the underside of the cleaning head clean, vacuum it at regular intervals using the crevice tool. Or, disconnect the Pod from the mains supply and remove dust by using a soft damp cloth and wipe dry. Do not use scourers or abrasive cleaners. Brush motor protection If the rotating brush is stalled, the brush motor stops automatically. Switch off and unplug the cleaner before removing any article trapped in the brush. The brush motor protection will only reset after the power has been disconnected. Floor nozzle access If a blockage occurs in the floor nozzle airpath, the panel on the bottom of the floor nozzle may be removed. 1 First disconnect the cleaner from the mains supply and remove the floor nozzle. [. . . ] · Check the filters for blockages. · Check the hose and tubes for blockages. · Check the plug is firmly in the socket and the supply is switched on. · Make sure the socket is working by trying another appliance. [. . . ]