User manual MORPHY RICHARDS IB73303

[. . . ] Use only genuine Morphy Richards spare parts and accessories Never over-extend the hose such that the cleaner is pulled over. If the cleaner is knocked over, switch off before attempting to upright. Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. WARNING: Keep loose clothing, hair, fingers etc. [. . . ] · If additional length is required, attach one or both extension tubes between the hose and tool. IMPORTANT: Never over extend the hose such that the cleaner is pulled over. B Use attachments E C Use DEEP CARPET HARD FLOOR Clean under furniture Flat position 4 8607 Upright ib 73303 29/07/2003 11:00 Page 5 Dust bag condition When the cleaner is switched on, if the dust bag condition indicator is continuously showing red (or if the suction is reduced) the bag must be replaced and the filters cleaned. If it is still showing red after emptying the dust bag and cleaning the filters, check to see if the hose is blocked. Changing the filters F Changing the dust bag E 1 Unplug power cable from wall socket. 2 Remove the front by pressing the release lever at the top. 3 Remove the old dust bag by holding the cardboard tab and pull towards you. Remove carefully to avoid dust/dirt spilling from dust bag and dispose. 4 Take a new dust bag and fold over the top tab at the crease. Holding the cardboard tab, push the bag over the opening of the dirt discharge tube until it is seated against the rear of the enclosure. 5 The front panel will not close unless the dustbag is correctly fitted due to the safety bag interlock. Always check the pre-motor and post motor filters every time you change the dust bag. 6 Once the new dust bag is in place, replace the front panel by aligning the bottom locking tabs with the slots in the body, close cover slowly allowing the front panel to snap in place. The latch will self lock. Everytime a new bag is fitted, the filters should be taken out and cleaned. Failure to clean the filters will reduce the suction and will damage the motor if used for prolonged periods. If the filters become damaged they must be replaced. IMPORTANT: Do not operate the cleaner without the filters in place. 1 Remove the front cover of the cleaner. 2 The pre-motor filter is located underneath the bag and the exhaust filter is below facing forward. To remove the pre-motor filter, simply slide it forward. To remove the exhaust motor filter, pull the locking tab on the right and it will snap out. 3 Remove the filters from their holders by unclipping and shake vigorously over a dustbin. The pre-motor filter may also be washed in warm water. The filter must be completely dry before re-fitting. [. . . ] 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 Where the appliance has been used for hire purposes or non-domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Consumables such as bags, filters and belt are not covered by the guarantee. All Morphy Richards Products are individually tested before leaving the factory. [. . . ]