User manual MORPHY RICHARDS IB73320

[. . . ] Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. Use only genuine Morphy Richards spare parts and accessories Never over-extend the hose such that the cleaner is pulled over. If the cleaner is knocked over, switch off before attempting to upright. [. . . ] Choose the setting which most closely matches your floor surface. · Use the DEEP CARPET setting when using the tools. Note: The height adjustment only comes into effect when the handle is released by the handle release pedal È. B C DEEP CARPET TOOLS HARD FLOOR D min max MEDIUM CARPET 4 73320 Rev 3 17/1/05 2:38 PM Page 5 Using attachments Follow steps 1-4 (using on carpets) but set the carpet height adjustment knob to deep carpet setting. 5 Remove the hose connector Í from the rear of the cleaner. Lift the hose · from the top handle hook. Insert the hose clip ~ into the hose clip slot Ë. · Push the required attachment firmly onto the end of the hose. · If additional length is required, attach one or both extension tubes. · IMPORTANT: Always fix the hose clip ~ to the main body slot Ë when using the hose and tools. · Never over extend the hose such that the cleaner is pulled over. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. Emptying Empty the dust canister regularly even if it does not look full this will maintain the performance. 1 Remove the front cover by lifting the cover release lever. E 2 Lift-up the dust canister release and pull the canister away from the main body. 4 Turn the lid 1/4 turn anti-clockwise to unlock, lift off the lid with pleated filter, Ì put to one side. F 5 Lift out the central mesh filter Ô from the dust canister G. 8 Shake the pleated filter to remove all dust. 9 Re-fit pleated filter with lid into the dust canister and turn lid 1/4 turn clockwise to lock. 10Re-fit dust canister into cleaner and push to lock into position. Then re-fit front cover. F Ì Ï Ô Safety cut-out If the cleaner overheats a motor protection thermostat will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for at least 30 minutes. Check the airways for blockages, empty dust canister and clean the filters before restarting. Ó Î ¤ E < 5 73320 Rev 3 17/1/05 2:38 PM Page 6 Cleaning the filters To maintain suction the pleated filter must be shaken clean each time the dust canister is emptied. Failure to clean the filter will reduce suction and could damage the motor if used for a prolonged period. [. . . ] 17 Turn the cleaner face down and re-fit and tighten the four fixing screws, do not overtighten. 18 Return the cleaner to its correct working position before re-testing. L Û Ù ^ J iM K N 7 73320 Rev 3 17/1/05 2:38 PM Page 8 Your two-year guarantee · It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]