User manual MORPHY RICHARDS IB73340

[. . . ] Use only genuine Morphy Richards spare parts and accessories Never over-extend the hose such that the cleaner is pulled over. If the cleaner is knocked over, switch off before attempting to upright. Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. WARNING: Keep loose clothing, hair, fingers etc. [. . . ] · Push the required attachment firmly onto the end of the hose. · If additional length is required, attach one or both extension tubes between the hose and tool. · IMPORTANT: Always fix the hose clip È to the main body slot Ë when using the hose and tools. · Never over extend the hose such that the cleaner is pulled over. · Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. B C DEEP CARPET TOOLS HARD FLOOR MEDIUM CARPET 4 73340 Rev 1 4/3/05 10:29 AM Page 5 Dust bag indicator When the cleaner is switched on, if the dust bag condition indicator is continuously showing red (or if the suction is reduced) the bag must be replaced and the filters cleaned. If it is still showing red after emptying the dust bag and cleaning the filters, check to see if the hose is blocked. 6 Once the new dust bag is in place, replace the front panel by aligning the bottom locking tabs with the slots in the body, close cover slowly allowing the front panel to snap in place. The latch will self lock. Cleaning the pre-motor filter E Changing the dust bag D 1 Unplug the power cable from the socket. 2 Remove the front by pressing the release lever at the top. 3 Remove the old dustbag by holding the cardboard tab and pull towards you. Remove carefully to avoid dust/dirt spilling from the dust bag and dispose. 4 Take a new dust bag and fold over the top tab at the crease. Holding the cardboard tab, push the bag over the opening of the dirt discharge tube until it is seated against the rear of the enclosure. 5 The front panel will not close unless the dust bag is correctly fitted due to the safety bag interlock. Í Always check and if necessary clean the pre-motor filter every time your change the dust bag. Everytime a new bag is fitted, the filter should be taken out and cleaned. Failure to clean the filter will reduce suction and will damage the motor if used for prolonged periods. If the filter becomes damaged it must be replaced. IMPORTANT: Do not operate the cleaner without the filter in place. 1 Remove the front cover of the cleaner. 2 The pre-motor filter is located below the bag. 3 To remove the filter, slide the holder out of the machine. 4 Remove the filter from the holder by unclipping. To clean shake vigorously over a dustbin. [. . . ] 18 Return the cleaner to its correct working position before re-testing. ÌJ Ó I Î K Ï 7 73340 Rev 1 4/3/05 10:29 AM Page 8 Your two-year guarantee · It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. [. . . ]