User manual MORPHY RICHARDS IBFILTERRK

[. . . ] · Always close the lid securely, otherwise the kettle may not switch off automatically and may spit out boiling water. · Avoid contact with steam from the spout when the water is boiling or just after it has switched off. · Take care if opening the lid for re-filling when the kettle is hot. · Do not fill above the MAX mark, otherwise boiling water may be ejected and filtration may be impaired. [. . . ] Before use 1 Remove cartridge from the packet and soak in a bowl of water for 20 minutes. 2 Take the top compartment (the cartridge holder) out of the kettle by pulling the cartridge holder easy release button Á forward and lift upwards. 2 Allow water to filter through system, discard the water and repeat once more. The amount of water must cover the kettle element. Do not fill above the maximum mark or filter performance will be impaired. Always ensure the kettle is emptied before refilling. Electronic cartridge reminder After changing the cartridge and for first usage, the counter must be reset. 1 Hold the start button for 3 seconds (100% will show on the display and the outer ring will flash). The display will then switch off due to its energy saving device after 3 minutes. 3 Insert the cartridge into the top compartment from the bottom and twist clockwise to lock in place. 2 You can check the progress of your cartridge at any time by pressing the start button for 1 second. The counter will count down from 100% to 25%. 3 25% turns off when the cartridge needs replacing. The outer ring of the display will flash and continue to flash until the cartridge has been changed. 4 Replace the cartridge holder back into the kettle and click into place. Filling the kettle 1 Fill the kettle with tap water to the maximum mark either by lifting up the lid or by sliding the filler slider to one side as shown. 4 Reset the reminder as per point 1. 4 Replacing electronic cartridge reminder When the cartridge reminder is due for renewal it can easily be removed. 1 Pull both tabs upwards and lift out the cartridge reminder. 2 To refit your new cartridge reminder, slot tabs into the lugs provided and click into place. · If you are using the kettle for the first time, discard the water and repeat once more. · To re-boil, switch to ON again. If the kettle has just switched off wait a minute or so before switching it back on again. · If you do not put in enough water, or switch on the filter kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. 5 Lift the filter kettle from the base unit by the handle ensuring you hold the kettle level. WARNING: Unless the cartridge holder is fitted correctly, the filter kettle may not operate correctly and the lid may not close and lock securely. Telephone our replacement parts helpline for your new cartridge reminder. Switching on You do not need to wait until the water has filtered through before boiling. [. . . ] 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters/cartridges for all Morphy Richards filter jugs and kettles are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. [. . . ]