User manual MORPHY RICHARDS IBGRIMEBSTR

[. . . ] If the fault develops after 28 days and within 24 months of original purchase, you should take the appliance to your nearest service agent. A list containing details of your nearest service agent is included with your appliance but please contact the helpline quoting Model number and Serial number should you require further assistance, Repair or replacement of the product is subject to the following exclusions (see Exclusions). If you suspect a fault, follow the simple checks detailed below before returning the appliance or calling the helpline: 1 -Check the plug is firmly in the socket and the supply is switched on. 2 -Make sure the socket is working by trying another appliance. [. . . ] (Fig D). A Do not use any detergents. Screw the filler cap (1) clockwise until finger tight. Attaching Hose and Accessories Pull down flap on the front of the machine socket. Insert the plug on the end of the hose (11) into the machine socket (4) with button side facing up, and push firmly until it clicks into place. (Fig B) F The fit between the connector and the tubes and/or handle is tight to ensure no steam leaks. It is recommended to keep both parts lubricated to facilitate connecting and disconnecting. To detach the accessories, press the release button (16) and pull the items apart. Please be careful not to trap your fingers. D Some tasks may be easier with only one tube fitted or none at all. OPERATING YOUR STEAM CLEANER To connect the desired accessory directly to the steam handle, slide the handle into the accessory head until it locks into place. When using the large floor brush (20) or the triangular brush (27), the brush connector (21) needs to be fitted to the brush first, in order to attach the same to the extension tube. Push the connector end, holding it upside down, fully into the brush inlet. (Fig E) Connect the unit to the mains and switch on the boiler heater by pressing the on-off button (2). The `heater on' light is illuminated. When the steam is ready for use the `steam ready' light (6) will turn green. Make sure that the locking mechanism (14) on the handle has been released. If you push the lock (14) towards the rear, the steam switch can not be operated. Push the lock forward so that the steam switch is released. (Fig G) 17 H If the `refill' indicator light (7) turns red, the boiler must be refilled. B 4 5 Refilling When the `refill' light (7) turns red there should be no steam available for release. The boiler needs to be refilled: Switch off the boiler heater by pressing the on/off button (2) If there is pressure in the boiler, the filler cap (1) will revolve but a safety feature prevents it from being unscrewed. Release any steam pressure in the system using the on/off switch (3) on machine and handle (13). Switch off the steam release button (3). Leave the product with the filler cap off for 10 minutes before filling. Refill the boiler using the funnel (Fig A). [. . . ] Use a putty knife to lift the loosened wall paper, and pull it off completely. * These accessories are available as optional extras, if not supplied with your machine. Please contact your helpline for more information MAINTENANCE & TROUBLESHOOTING Mix one litre of water with 0. 25 litre of vinegar and pour into the boiler with the funnel provided. Shake the cleaner and then allow the mixture to work for at least one hour. [. . . ]