User manual MORPHY RICHARDS ILLUMA GLASS KETTLE REV 1

[. . . ] · Do not fill above the MAX mark, otherwise boiling water may be ejected. · Do not hold the switch in the on position or tamper with the switch to fix it in the on position as this may cause damage to the switch-off mechanism. · Unplug from the outlet before cleaning. · Allow to cool before putting on or taking off parts and before cleaning. Location · Always locate your kettle away from the edge of the worktop. [. . . ] Use the lid release button ¤ to open. · IMPORTANT : When filling from a tap, care must be taken to avoid striking the glass body on the tap. · Always ensure that the level of water in the kettle is filled to at least the minimum level shown on the water level indicator. · Boil only as much water as you need as this saves electricity. 2 Place the kettle on the base unit, ensuring the kettle locates on to the 360° connector. · The 360° connector allows the kettle to be located at any position. - ideal for left and right handed users and for convenient positioning on worktop. 3 Plug in and switch on at the wall socket. The `power on' neon and the kettle glass body, will light up. 5 When the water boils the kettle will switch off automatically. · If you are using the kettle for the first time, pour away the boiled water and refill. 6 Lift the kettle from the base unit by the handle ensuring you hold the kettle level. · To re-boil, switch to ON again. If the kettle has just switched off wait a minute or so before switching it back on again. · If you do not put in enough water, or switch on the kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. Filter removal 1 Open the lid using the release button ¤. 3 To refit the filter, slide it into the side guides of the filter holder until it clicks into place. WARNING: Unless the filter is fitted correctly, the kettle lid may not close and the kettle may not switch off after boiling. 4 43121 rev 1 11/4/05 10:34 AM Page 5 Descaling IMPORTANT: As this kettle is fitted with a concealed element it must be descaled regularly. Frequency of descaling depends on usage and the hardness of the water in your area. Excessive scale can cause the kettle to switch off before boiling and may damage the element invalidating the warranty. It is essential that regular descaling takes place. Remove hard scale using a proprietary descaling product suitable for glass kettles. [. . . ] 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. [. . . ]