User manual MORPHY RICHARDS INTELLIDOME

[. . . ] RN42236MUK Rev2_Instruction Book 25/10/2010 11:38 Page 1 Upon registration with Morphy Richards (UK & ROI only) Register online for your 2 year guarantee. See back of this instruction book for details. (UK and Ireland customers only) www. morphyrichards. co. uk TM Ironing system (pressurised) Please read and keep these instructions Getting the best from your new ironing system. . . . Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. Water tank The fixed water tank can be re-filled at any time during ironing. Performance To extend the performance and life of your IntelliDome generator, ensure that you replace the anti-scale filter according to the on-board indicator. [. . . ] The LCD display screen , , will illuminate for 1-second and be accompanied with a short beep sound, then the unit will turn off and will remain in STANDBY mode until re-activated. The STANDBY ICON is also visible in the corner of the display screen. 4 Press the POWER STANDBY button to activate the unit and set the iron temperature control dial on the iron to the 3-dot setting. At this time, the pump will fill the boiler with water. You will hear the pump operating - this is quite normal. The filling sequence takes approximately 25 seconds. The unit will heat and automatically default to the LOW STEAM level, the STEAM ICON will flash on the display screen and will remain permanently on when steam is available for ironing. The AUTO STANDBY feature will activate if the iron is not used for 15 minutes. Press the POWER STANDBY button or steam trigger to reactivate the iron. I MEDIUM STEAM LEVEL J HIGH STEAM LEVEL The STEAM ICON will flash until the unit reaches the selected temperature. Once the temperature has been reached, the STEAM ICON will remain lit. When navigating though the steam settings, a SHORT BEEP will be heard for every operation of the STEAM SETTING +/- buttons a further LONGER BEEP will be heard once the unit has reached the selected setting. Note: During ironing, the pump will operate periodically to `top up' the boiler with water. This is quite normal and lasts for a few seconds only. VERTICAL STEAM Hold the iron in a vertical position between 1cm and 2cm away from the item K. Press the steam trigger /, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings etc. Steam settings To increase or decrease the steam setting, press the STEAM SETTING +/- buttons. These settings include: NO STEAM G, LOW STEAM LEVEL H, MEDIUM STEAM LEVEL I and HIGH STEAM LEVEL J. K G STEAM FUNCTION NO STEAM During the steaming process, small amounts of water may be ejected from the soleplate. This is normal and can be avoided by using the steam for short amounts of time and only when the iron is at the correct temperature (the indicator light on the iron goes out when ready). Sudden jolts of the boiler unit can also cause water droplets on the soleplate; therefore, do not move the base unit during ironing. We recommend for the first time ironing that you iron over an old towel. 11 11 H LOW STEAM LEVEL For details of other Morphy Richards products, please see our website: RN42236MUK Rev2_Instruction Book 25/10/2010 11:38 Page 12 3. DRY IRONING Always make sure there is water in the tank otherwise the LOW WATER indicator will activate. 1 Always make sure the water tank is quarter full, otherwise the LOW WATER INDICATOR ICON will activate. The LCD display screen will illuminate for 1 second accompanied by a short beep sound, the unit will then turn off and will remain in STANDBY mode until re-activated. [. . . ] Subject to the exclusions set out below (see Exclusions), the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. If, for any reason, this item is replaced during the 1 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase. To qualify for the 1 year guarantee, the appliance must have been used according to the instructions supplied. [. . . ]