User manual MORPHY RICHARDS ORB CYCLONE VACUUM CLEANER REV 3

[. . . ] · Never use the appliance to vacuum hot ashes, broken glass, sharp objects or liquids. · To protect against fire, electric shock and personal injury do not immerse cord, plug or cleaner in water or other liquid. Location · Do not use or keep this product outside when it is raining. · Do not store the appliance near hot ovens or heating appliances. Mains lead · Do not allow the mains lead to become strained or run this appliance over it. · If the electrical cable becomes damaged the complete cable assembly must be replaced. [. . . ] 5 Re-insert the dust container into the product and close the lid to re-fit. G G D Cleaning the dust compartment filter 2 Lift the container away from the product. E It is essential that filters are cleaned regularly to maintain performance. 1 Remove the dust container from the product as detailed in the previous section. 2 Lift the filter out of the container. H. E H 3 Holding the dust container over a dustbin, lift up the flap on top of the handle and press the dust container release button as shown F the bottom of the dust container will drop down to release the dirt. F 5 orb cyclone 73170M REV 3 17/6/05 8:46 AM Page 6 3 Remove the top foam filter as shown I. The pleated filter can be gently knocked against the side of the dustbin to remove excess dust. Cleaning the exhaust filter I The exhaust filter is located at the back of the product. To remove, press the clip and pull the filter cover away from the product. K Remove the filter. To refit the filter, reassemble and locate into the hole in the top of the dust container. · The filter should be regularly washed in cold water and left to air dry before inserting back into the machine. IMPORTANT: Do not use detergents to clean the filter. The filter must be thoroughly dry before the machine is used. IMPORTANT: The dust container will not lock back onto the machine unless the filter is fitted correctly. K The exhaust filter is non-washable. To remove fine dust use the crevice tool brush to gently clean between the pleats. It is recommended that the exhaust filter is replaced every 6 months or sooner if it becomes damaged. IMPORTANT · All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must be replaced immediately if they become damaged. · Always disconnect the cleaner from the mains when checking filters. · Always make sure all filters are fitted before use. Failure to do so may result in damage to your product. Pre-motor filter An additional pre-motor filter is located underneath the dust compartment lid. Lift up the lid, the filter is located to the rear. J This should only require occasional cleaning. [. . . ] 2 The appliance has been used on a voltage supply other than that stamped on the products. 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 Where the appliance has been used for hire purposes or non domestic use. 5 The guarantee excludes consumables such as filters. [. . . ]