User manual MORPHY RICHARDS PERFORMAIR CYCLONIC VACUUM CLEANER 71062

[. . . ] Do not allow the mains lead to become strained or run this appliance over it. if the electrical cable becomes damaged the cable assembly must be replaced. Do not attempt this task yourself, contact the helpline number that is found at the back of this booklet. Children do not understand the dangers associated with operating electrical appliances. [. . . ] Combination floor nozzle Large turbo nozzle Small turbo nozzle Hard floor nozzle Crevice tool Upholstery Hair and nozzle Stair tool with clip on-brush With brushes down With brushes down For example, maximum suction can be used for cleaning carpets, hard floors etc. and reduced suction for cleaning upholstery and curtains. Suction can also be controlled using the airflow regulator on the hose handle. To obtain the best results from your cleaner empty the dust canister regularly, otherwise the airflow and cleaning power will be reduced. 1 Everytime the dust canister is emptied, turn the yellow dial (a minimum of 5 revolutions) prior to pressing the dust canister release button (this will agitate the fine dust between the filter pleats and restore the air flow) Remove the dust canister from the product by pressing the dust canister release button < Lift up the lid and remove the canister from the product, pulling the dust canister away from the product C. Holding the dust canister over a dustbin press the dust release button as shown D, the bottom of the dust container will drop down to release the dirt. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. Close the bottom of the dust canister by pressing the base upwards until it clicks into place. Make certain the dust canister feet are located in place. The dust container may not lock back onto the machine unless the filter is fitted correctly Press the catch and pull the exhaust grille away F. Pull the bottom of the filter outwards so the top of the filter unhooks from the filter recess. foam filters may be washed (in cool water) , thoroughly air-dried and refitted. The pleated filters used on the Allergy models cannot be washed and should be replaced every 6 months or sooner depending on use. IMPORTANT: To re-fit the filters, first hook the top of the filter into the filter recess then push the bottom of the filter into location G. Note: If the filter is not correctly hooked in the exhaust filter grille will not close. After fitting the filter, re-fit the exhaust filter grille by hooking the bottom of the grille in first and then pushing the top close until it clicks fully closed. IMPORTANT: All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must be replaced immediately if they become damaged. Always disconnect the cleaner from the mains when checking filters. Always make sure all filters are fitted before use. Failure to do so may result in damage to your product. 1 Place the container inside the plastic bag, releasing the container with one hand whilst holding the top of the bag closed with the other, leave the dust to settle for a few seconds before carefully removing the empty canister. [. . . ] This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. This appliance is guaranteed for 2 years against faulty material, components and workmanship. This warranty is in addition and does not affect your statutory rights. Proof of purchase must be produced for any warranty benefit. [. . . ]