User manual MORPHY RICHARDS STEAM GENERATORS 42271

[. . . ] · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. · If the supply cord is damaged, it must be replaced by the manufacturer, it's service agent or similarly qualified persons in order to avoid a hazard. Other safety considerations · Use the steam generator only for it's intended use. · Never hold the generator base set under the tap. · To protect against the risk of electric shock, do not put the appliance in water or in any other liquid. [. . . ] A 3 Remove the anti-scale cartridge by pulling upwards B. B Â 4 42271 rev4 30/7/08 15:56 Page 5 4 Fill the tank up to the `fill to here' line with clean tap water C. Never use battery C topping up fluid or water containing any substances like starch or sugar, or defrosted water from a refrigerator. 5 Re-install the anti-scale cartridge and replace the water tank on the base unit D. D 6 Always pour out remaining water after use. also illuminate, indicating the boiler is on it's heating cycle and will extinguish when the required temperature is reached. 5 Turn the temperature dial on the iron in a clockwise direction, select dot-1, dot-2 or dot-3 according to the recommendation of the garment label. 6 The iron's temperature indicator light > goes off when the required temperature is reached. 7 Depress the steam button / for one minute to clean the steam generating system (for first time use). It will be accompanied by a clicking noise which is quite normal. 8 Begin first time ironing with an old towel. It takes one minute to reach the required temperature. 9 Press the steam button for steam ironing. 10 To switch the unit off, turn the power switch on the base unit to `O' (OFF). Re-filling 1 When the water level reaches a low level, the pump begins to emit a loud noise. This is due to air being pumped instead of water and is quite normal. Refilling can be done whilst the appliance is in operation. It is not necessary to wait for the appliance to cool down. 2 Slide out the water tank and fill (see `Filling' instructions). Dry ironing 1 Connect the appliance to a suitable mains outlet. 2 Turn the temperature dial on the iron in a clockwise direction, select dot-1, dot-2 or dot-3 according to the recommendation of the garment label. 3 The temperature indicator light glows on the iron, indicating that it is switched on. 4 When the required temperature is reached, the temperature indicator light on the iron goes off. It is always a good idea to begin with 'cool' fabrics and work up to higher settings. An iron heats up quicker than it cools down, so you'll save time and electricity. Steam ironing 1 Unwind and straighten the power cord · and supply cord fi. 2 Slide out the water tank and fill (see `Filling' instructions). [. . . ] If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You may be asked to return a copy of proof of purchase. Subject to the exclusions set out below (see Exclusions), the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. If, for any reason, this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from the original purchase date. [. . . ]