User manual MORPHY RICHARDS TURBOSTREAM IRON 40684

[. . . ] Never yank the cord to disconnect from the socket, instead, grasp the plug and pull to disconnect. Do not allow the cord to touch hot surfaces. Let the iron cool completely before putting away. Loop the cord loosely around the iron before storing. [. . . ] If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 4 UK Helpline 0844 871 0953 Replacement Parts 0844 873 0719 Ireland Helpline 1800 409 119 40684 rev3 17/6/08 17:03 Page 5 FILLING A 1 Make sure that the iron is not plugged in and then set the variable steam control < to the `0' position before filling the iron with water. Open the fill cap and pour water through the filling hole > into the water tank ·, using the beaker provided. One beaker full of water fills the tank (400ml) A. In hard water areas, the use of distilled or demineralised water is recommended. Never use battery topping up fluid or water containing any substances like starch, or sugar, or defrosted water from a refrigerator. 3 Always pour out the remaining water after use. Warning: When filling your iron with tap water, always use the beaker provided. Never fill directly under the tap. FEATURES OF YOUR A IRON Temperature indicator light The indicator light under the control knob shows that the iron is warming up. When the required temperature is reached, the light will go out and will cycle on-off during operation. 2 Dry ironing You can use your iron as a dry iron only. Make sure the variable steam control < is set to the `0' symbol. Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see `Filling' section). You do not need to put any water in the tank when dry ironing only. B Temperature control B Plug in the iron and switch on. The `power on' indicator lights , , , situated in the back cover, will illuminate. Set the temperature control dial B to the temperature required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Spray C Press the spray button ¤ and aim the spray of water at stubborn creases. You can do this whilst dry ironing, providing there is water in the tank. When using the water spray, it may be necessary to push the button a few times to get the spray pump primed. C Variable steam D Fill the iron with water as described in `Filling', and insert the plug into the electrical socket. [. . . ] This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. This guarantee is valid in the UK and Ireland only. 5 6 7 · EXCLUSIONS Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: 1 The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturer's recommendations, or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. Repairs have been attempted by persons other than our service staff (or authorised dealer). [. . . ]