User manual MORSO 2140

[. . . ] Morsø, the largest stove manufacturer in Denmark, has been making cast-iron stoves of the highest quality since 1853. By carefully following the instructions below, we are certain that you will enjoy many years of comfortable warmth from your new Morsø stove. Additional accessories Morsø also offers a comprehensive line of floor plates and accessory products that can facilitate the safe and efficient operation and maintenance of your Morsø stove. 10: After removing the outer packaging, unbolt the combustion chamber from the wooden pallet and place it gently on its back. [. . . ] If smoke spillage occurs when the fire door is opened, it is probably due to poor chimney draft. This type of stove requires at least 1 pa of chimney draft to achieve satisfactory combustion and smoke spillage prevention. However, in cases where the stove door is opened too vigorously you could expect that slight smoke spillage may occur. the flue gas temperature at the rated output is 6° C. If you have any doubts, you may want to have your installer measure the draft in the chimney. The chimney's draft is the resulting effect within the flue caused by the difference in temperature within the flue and the cooler temperature outside. Other factors that can influence the level of draft include the length of the flue, insulation of the chimney, adverse weather conditions or tall buildings or trees nearby the flue terminal. The atmospheric temperature difference is too low, e. If the chimney is excessively cool, it may help to `prime' the flue before the fire is lit. The chimney is not tall enough, with the result that the terminal sits in the lee of the roof surface or in the vicinity of tall trees or neighbouring buildings. These conditions are also associated with downdraft where the flue gases are pushed back down the chimney. By soot, due to inadequate cleaning, loose debris or even a birds nest. The house is too tightly sealed (see section on Fresh air supply). The temperature difference between the chimney and outside is high. This also applies during firing, when the need is greatest. The weather is clear and there is a good wind. Minimum 4 meters over the stove and the termination adequately clear of the roof line. For wood firing, the riddling grate should be closed. The efficiency is 76% Your new Morsø stove is EN-tested and recommended to be fired with wood. Wood is a material that contains a great deal of gas (approximately 75 %). The gases are released when the wood is lit and heated up. For this reason, it is important that the gases are ignited quickly after stoking. [. . . ] The touch-up paint is available either as aerosol spray or as regular brush-on. Glass If the stove is used and installed onto a flue with the correct draft, very little or no deposits should appear on the ceramic glass. It is usual for soot deposits to appear during long slumbering fires however, once the fire has been re-established to a burn brightly, these deposits will burn off. If the glass window becomes thoroughly covered in soot due to faulty operation or poor draft, the soot can be easily removed using, e. [. . . ]