User manual MOTO GUZZI V7 CLASSIC

[. . . ] We have drawn up this booklet to provide a comprehensive overview of your vehicle's quality features. Please read it carefully before riding the vehicle for the first time. it contains information , tips and precautions for using your vehicle. It also describes features, details and devices to assure you that you have made the right choice. [. . . ] During the first 100 km (62 miles) operate the brakes with caution, avoid rough and long braking. START-UP WITH FLOODED ENGINE The engine may get flooded if the startup procedure is not properly carried out or there is excess fuel in the inlet ducts. to clean a flooded engine: · Press the starter button (1) for a few seconds (running the engine with no gear engaged) with the throttle grip (3) fully twisted (Pos. COLD START If the ambient temperature is low (near or below 0°C), there may be problems with the first start-up. Turn the cold start lever (2) downwards. Press the starter button for at least ten seconds and at the same time gradually turn the throttle grip (3). If idle speed is not stable, twist the throttle grip (3) slightly and frequently. Wait for a few seconds and repeat the start-up procedure. When getting on and off the vehicle, make sure nothing is restricting your movements; do not hold any objects in your hands (helmet, gloves or goggles not put on). Always get on and off the vehicle on the left side and with the side stand lowered. ATENCIÓN EL CONDUCTOR ES SIEMPRE EL PRIMERO QUE ASCIENDE AL VEHÍCULO Y EL ULTIMO EN DESCENDER Y ES EL QUE GOBIERNA EL EQUILIBRIO Y LA ESTABILIDAD DURANTE EL ASCENSO O DESCENSO DEL PASAJERO The stand has been designed to support the weight of the vehicle and a minimum load, without the added weight of rider and passenger. The purpose of the side stand is to prevent the vehicle from falling or overturning while rider and passenger get on the vehicle and get ready to ride; the stand should not be used to support the weight of rider and passenger. While getting on and off, the vehicle may become unstable due to its weight and it may fall or overturn. When getting on and off the vehicle, the passenger must move carefully so as not to cause a loss of stability for vehicle and rider. Grip the handlebar correctly and get on the vehicle without resting your weight on the side stand Place both feet on the ground, straighten and balance the vehicle keeping it upright in riding position. Ask passenger to fold out both passenger footrests. Instruct passenger on how to get on the vehicle safely. Push the side stand with your left foot to fold it up completely. With the left shoe heel, lower and extend the side stand completely. Place both feet on the ground and balance the vehicle keeping it upright in riding position. Instruct the passenger on how to get off the vehicle safely. In general terms, scheduled maintenance can be carried out by the owner; however, some operations may require specific tools and technical training. [. . . ] During transport, the vehicle must be well anchored and upright, and first gear must be engaged to avoid fuel and oil leaks. Minimum ground clearance Kerb weight Engine revs at idle speed Intake valve clearance Outlet valve clearance Clutch 0059 in) dry single-disc clutch with antivibration buffers Pressure-fed lubrication system adjusted through valves and a trochoidal pump cartridge, dry air Mechanical, 5 speeds with foot lever on the left-hand side of the engine 66 USgal) oil change and oil filter replacement: 1780 cm³ (108. Gearbox oil Transmission oil Seats Swinging arm in die-cast light alloy, 2 shock absorbers with adjustable spring preloading 100 mm (3. 59 in), callipers with 4 different and counteracting plungers stainless steel disc; Ø 260 mm (10. [. . . ]