User manual MOTOROLA CP040

[. . . ] Before using this product, read the RF energy awareness information and operating instructions in the Product Safety and RF Exposure booklet (Motorola Publication part number 6864117B25_) to ensure compliance with RF energy exposure limits. OPERATION AND CONTROL FUNCTIONS Radio Controls The numbers below refer to the illustrations on the inside front cover. Push-to-talk (PTT) Press and hold down this button to talk; release it to listen. 3 English RADIO OVERVIEW On-Off / Volume Knob Used to turn the radio on or off, and to adjust the radio’s volume. [. . . ] Disengage by pushing downward and holding the latch towards the front of the radio. With the battery latch disengaged, slide the battery down from the top of the radio approximately 1 cm. Once the battery is free from the battery rails, lift it directly away from the radio. 2 3 3 English Attaching the Antenna Removing the Antenna GETTING STARTED Turn the antenna clockwise to attach it. turn the antenna counter-clockwise to remove it. 9 English Attaching the Belt Clip GETTING STARTED 1 Align the grooves of the belt clip with those of the battery. Press the belt clip downward until you hear a click. Removing the Belt Clip Belt Clip Tab 1 Use a key to press the belt clip tab away from the battery to unlock the belt clip. slide the belt clip upward to remove it. 2 2 English 10 1 Hold down the Volume Set button; you will hear a continuous tone. Turn the On/Off/Volume Control knob to the desired volume level. If power-up is successful, you will hear the Self-Test Pass Tone ( ) and see the LED flash green. If the radio fails to power up, you will hear the Self Test Fail Tone ( ). OFF Turn the On/Off/ Volume Control knob counter-clockwise until you hear a click. 3 SELECTING A RADIO CHANNEL Your radio offers 4 or 16 channels. Note: Due to government regulations, some channels may not be programmed. To select a channel, turn the Channel Selector knob clockwise or counterclockwise until you reach the desired channel. 11 English GETTING STARTED TURNING THE RADIO ON OR OFF ADJUSTING THE VOLUME SENDING A CALL 1 2 Turn your radio on. Use the Channel Selector knob to select the desired channel. Hold the radio in a vertical position, press the PTT, and talk at a distance of about 2. MONITORING It is important to monitor traffic before transmitting to ensure that you do not “talk over” someone who is already transmitting. 1 Press and hold the preprogrammed Monitor button to access channel traffic. [. . . ] Your radio automatically switches to a scan list channel when it detects activity on it. TALKBACK If the Talkback option is preprogrammed, you can respond to any calls received during the scan operation. To respond, press the PTT button before the programmed hangtime elapses. Otherwise, the radio will continue scanning. [. . . ]