User manual MOTOROLA H620

[. . . ] The indicator light turns red or yellow when the battery is charging. It may take up to 1 minute for the indicator light to turn on. When the headset's battery is fully charged (about 2 hours), the indicator light turns green. Note: Headset is not functional while charging. [. . . ] To use your headset, turn on the Bluetooth feature in your phone. Please check your phone's user's guide. Note : The Bluetooth feature remains on until you turn the feature off. Before you can use your headset, you must pair it with your phone. 1 Ensure headset is in pairing mode Power on headset by sliding the Power switch towards the microphone to initiate easy pairing. After a few moments, the indicator light will be steadily lit in blue to indicate headset is in pairing mode. If the headset does not enter pairing mode, see "Troubleshooting" for help. 2 Set your phone to look for your headset discovery, consult your phone's user's guide. The phone lists Bluetooth devices it finds. Motorola H620 in the list of discovered devices and confirm by following the on-screen prompts. Pairing is successful when the headset indicator light changes from steadily lit to flashing blue and purple. 6 English Test and use Your phone and headset are now paired and ready to make and receive calls. To confirm they are successfully paired and operating properly, place the headset over your ear and make a call from your phone. After you have successfully paired your phone and headset, you do not need to repeat these steps each time you use the headset. Note: If desired, your headset can be restored to original factory settings. This action will erase all pairing information stored in your headset. Thus, you will need to pair your phone and headset again. To restore your headset to original factory settings, press and hold both Volume buttons and the Call button at the same time for 10 seconds. Changing volume button orientation You can change the orientation of the volume buttons on your headset. Press and hold the Volume button you want to assign as the «volume up» button and slide the switch toward the microphone. [. . . ] Wait for the indicator light to become steadily lit in blue, indicating the headset is now in pairing mode. My phone doesn't find my headset Make sure the indicator light on your headset is on (lit in blue) and steady when your phone is searching for devices. My headset worked before but now it's not working Make sure your phone is on, and the Bluetooth feature is turned on in your phone. If Bluetooth was turned off or was turned on only temporarily, you may need to restart it and pair your phone and headset again. [. . . ]