User manual MOTOROLA HMEZ1000

[. . . ] · Consult the dealer or an experienced radio/TV technician for help. This device must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product. The term "IC:" before the certification/registration number only signifies that the Industry Canada technical specifications were met. Battery Life For your Motorola Home Monitoring & Control System devices that require batteries, use high quality, non-corrosive batteries designed for use in electronic equipment. Battery life is one year with normal usage. [. . . ] Click Next to accept the default destination folder or click Browse to select a new one. After you click Next, the Select Program Folder window is displayed. Accept the default folder or choose a new one. After a few moments, the Install Motorola Home Monitor Hardware and Driver window is displayed. Remove the back cover from your USB Gateway. Power Video Status Data 6 7 Plug the AC adapter into the Power port on the USB Gateway and into an AC wall outlet. Connect the USB cable on the Gateway to the USB port on your computer. Windows automatically installs the required drivers. USB port on PC (step 7) AC adapter (step 6) 8 9 10 If desired, replace the USB Gateway back cover as described in the Motorola Home Monitoring & Control System User Guide. Once the driver installation is complete, click Next. The Software installation was successful window is displayed. Be sure the checkbox "Launch Motorola Home Monitor" is selected. The Motorola Setup Wizard is displayed. Page 3 Quick Start Guide Easy Start Kit 11 12 13 Click Next. The Introduction to Detecting Wired Cameras window is displayed. If you purchased a wired camera, you can connect it now. The Introduction to Detecting Devices window is displayed. The Device Discovery window is displayed: Each device must be discovered to work with the system. 14 Plug in the wireless camera's 9V AC power adapter into an AC power outlet that cannot be switched on and off. If possible, we recommend powering the camera using its AC adapter. When AC power is not available, you can use batteries to provide power for about two hours of video transmission. The Wireless Camera must use AC power for the discovery process. To associate the Wireless Camera with your USB Gateway, push the discovery button on the camera with the discovery tool. After the camera is discovered, it is listed on the Device Discovery window. If desired, unplug the camera and move it to the desired location. [. . . ] Press the Discovery button found inside of the battery compartment. If this continues to fail, you will need to try another location for the camera. You may also try a hard reset by holding down the Discovery button while powering up the camera. After resetting the camera, please try to discover the camera again. [. . . ]