User manual MOTOROLA HMEZ2000

[. . . ] All types of cameras have difficulty seeing wide variations of light. The Motorola Day Camera is constructed of UV-resistant ABS plastic. Do not install the camera where it is subjected directly to the elements. The sensor's range is up to 60 feet (18 m) from the Wireless System Controller in a typical home, depending on the number of obstacles. [. . . ] Pull off the camera base by pulling straight down. The base detaches from the upper back side. Slide the camera down on to the bracket until it is firmly seated and you feel it click as the contacts engage. 4 Discovery button Detach base 3 4 Position the camera to view the desired area and plug in the power supply. Please keep in mind that the field of view is 80 degrees and the motion sensor distance works up to 12­14 feet (3. 5­4 m). Make adjustments to the camera viewing angle by tilting and panning the camera head with your hand. Table Mount Your Wireless Motion Sensor Camera The camera can be placed on any horizontal surface. 1 2 3 Place the camera on a horizontal surface. Plug the power supply into the camera and then to a wall outlet. Make adjustments to the camera viewing angle by tilting and panning the camera head with your hand. Installing Your Door/Window Sensor Installing your sensor is a simple process. 1 Locate the antenna and screw it into the top-right corner of the sensor, just above the air vents, until it is secure. Sharp objects should be stored out of reach of children to prevent injury. 2 Insert the batteries. On the bottom of the sensor, slide open the door and insert two AAA alkaline batteries. The back of the battery door of the sensor indicates the polarity (+ and -) of the batteries. Close the door after inserting batteries. The sensor does not support rechargeable NiCad or NiMH batteries. However, the sensor does employ built-in power saving functionality. 3 Register your sensor with your Wireless System Controller using a process called Discovery. Mount Your Door/Window Sensor Discover your sensor before mounting it. The spacing between the sensor and the contact should be between 1/10 inch and ½ inch (. 25 cm to 1. 27 cm). 1 2 Using the supplied double-sided tape, peel one side of the paper strip and place it on the back of the sensor. Peel the other side of the tape and place the sensor in the location desired. (See the diagram for sample mounting. ) You can also mount the sensor more securely using the screws in the hardware kit. Using the drilling template found later in this guide, drill two pilot holes for the screws. Affix the screws to one side of the object (typically the side to be attached to the door/window frame), leaving 1/16" (1. 6 mm) 5 1. 6 mm (1/16 inch) maximum space between the screw head and the object. Mount the sensor onto the screws and slide down to lock into place. Warning: When mounting near a window, drilling too close to the glass could break the glass, possibly cause it to shatter, and cause injury. The window extends deeper into the frame than can be seen; therefore, ensure your screw is beyond the glass before drilling. Install the Magnetic Contact 1 Using the double-sided tape provided, attach the magnetic contact to the part of the object that moves. You can also mount the contact more securely using the screws in the hardware kit and the drilling template provided later in this guide. [. . . ] The sensor transmits on the 418 MHz frequency. Ensure that the sensor registered with your Wireless System Controller. Ensure that you have the proper settings configured for the sensor. Ensure that you have the proper settings configured for the sensor. [. . . ]