User manual MOTOROLA OREILLETTE BLUETOOTH H500

[. . . ] When you see this symbol on a Motorola product, do not dispose the product with household waste. Recycling Mobile Phones and Accessories Do not dispose of mobile phones or electrical accessories, such as chargers or headsets, with your household waste. In some countries or regions, collection systems are set up to handle electrical and electronic waste items. Contact your regional authorities for more details. [. . . ] You can wear your H500 headset on your left of right ear. the headset comes ready for the right ear. Placing the headset on your ear: refer to figure 3 on page 2 Placing the headset on the left ear: refer to figure 4 on page 2 · If you change your headset to wear it on the other ear, you can also change the orientation of the volume buttons. 1 Turn the headset power off 2 Press the Call button and the volume button you want to assign as the "volume" up button until the indicator light flashes twice. Pairing your headset and phone Your phone's Bluetooth feature is off by default. Make sure the Bluetooth feature is turned on in your phone. If the Bluetooth feature was turned off or was turned on temporarily, you may need to restart the Bluetooth feature. please check your phone's user's guide. Before you can use your headset, you must pair (link) it with your phone. With the headset power off, press and hold the Call button for 5 seconds until the indicator light turns on and remain steadily lit. If the indicator light is flashing or does not remain steadily lit, turn off the headset and repeat this step. For details about device discovery, consult your phone's user's guide. Select Motorola H500 in the list of discovered devices and confirm by following the on-screen prompts. When prompted by the phone, enter the passkey 0000 and confirm. After you have successfully paired your phone and headset, you do not need to repeat these steps each time you use the headset. Your headset can store pairing information for up to 8 different devices equipped with Bluetooth wireless technology. Devices are stored in a "Paired Device List" in memory in chronological order. When an attempt to pair to more than 8 devices is made, the oldest paired device is removed from the list. The headset will automatically initiate a connection with the last device it was connected to either by powering up the headset or by pressing the Call button. If you want to connect the headset to another device in the paired device list, you must initiate the connection from that device. [. . . ] Note: after 5 minutes of inactivity, the light stop flashing to conserver power, but the headset is in standby mode. Audio tone Single high tone when pressing volume button 5 rapid high tones repeated every 60 seconds No audio indications: deteriorating quality Ring tone Single high tone Single low tone Dual high/low tone Single high tone Low to high tone 2 ascending tones 2 descending tones Headset status Volume at minimum or maximum Low battery Out of range Incoming call Pairing confirmation Voice activation Voice tag not recognized End call Phone network not available Mute enabled Mute disabled My phone does not find my headset: make sure the blue light on your headset is steadily lit when you phone is searching for devices My headset worked before but now it is not working: Make sure the Bluetooth feature is turned on in your phone. If the Bluetooth feature has been turned off or was turned on temporarily, you may need to restart the Bluetooth feature and pair your phone and headset again. If you have any additional questions, please call your hotline number (0800 553 109) or visit us at www. [. . . ]