User manual MOTOROLA SURFBOARD CABLE MODEM SB4101

[. . . ] SB4101 User Guide High-Speed Access to the Internet SURFboard Cable Modem R Regulatory Information Federal Communications Commission Radio and Television Interface Statement for a Class 'B' Device. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in the residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Double-click the Network and Dial-up Connections icon on the Control Panel window. On the Network and Dial-up Connections window, click Local Area Connection #. The value of this number (#) varies from system to system, but usually is 2. The Local Area Connection # Status window is displayed as shown at the top of the next page. Home Print X Exit 26 Introduction Before You Begin Installation Configuration Troubleshooting Legal Configuring for TCP/IP in Windows 2000 5 6 Click Properties and information similar to that shown in the lower window is displayed. If Internet Protocol (TCP/IP) is displayed in the list of network components, TCP/IP is installed and you can proceed to step 10. If TCP/IP is not displayed on the list, continue with step 7 by clicking Install. This causes the Select Network Component Type window to be displayed as shown at the top of the next page. Home Print X Exit 27 Introduction Before You Begin Installation Configuration Troubleshooting Legal Configuring for TCP/IP in Windows 2000 7 Click Protocol on the Select Network Component Type window and then click ADD. The Select Network Protocol window is displayed similar to the example on the lower left of this page. Click Internet Protocol (TCP/IP) in the Network Protocol section of Select Network Protocol window. Click OK and the Local Area Connection # Properties window is re-displayed as shown at the top of the next page. 8 9 Home Print X Exit 28 Introduction Before You Begin Installation Configuration Troubleshooting Legal Configuring for TCP/IP in Windows 2000 10 On the Local Area Connection # Properties window, make sure a check mark is in the box next to Internet Protocol (TCP/IP). The Internet Protocol (TCP/IP) Properties windows is displayed as shown on the lower left of this page. Make sure that "Obtain IP address automatically" and "Obtain DNS server address automatically" are selected. 11 Click OK to accept the TCP/IP settings. 12 Click OK to close the Local Area Connection # Properties window. 13 Click OK when prompted to restart your computer and then click OK again. Home Print X Exit 29 Introduction Before You Begin Installation Configuration Troubleshooting Legal Verifying Your IP Address in Windows 95, 98, and Me The following basic instructions are for Windows 95, 98, and Me. The instructions for verifying your IP address for Windows 2000 are found on the next page. For any other operating system, please refer to your specific operating system guide for IP address verification. To check the IP address: 1 The values shown for Adapter Address, IP Address, Subnet Mask, and Default Gateway on your PC will be different than those shown in the example above. On the Windows Desktop, click Start. A window similar to the example shown on this page is displayed. Select your adapter name--the Ethernet card or USB device. Click OK after the system displays an IP address. 2 3 4 5 6 If autoconfiguration is displayed before IP Address in Windows 98, call your service provider. If after performing this procedure your computer does not access the Internet, call your service provider. 30 Home Print X Exit Introduction Before You Begin Installation Configuration Troubleshooting Legal Verifying Your IP Address in Windows 2000 The following basic instructions are for Windows 2000. The instructions for verifying your IP address for Windows 95, and Me are found on the previous page. [. . . ] Software provided by third parties may be subject to separate end-user license agreements from the manufacturers of such Software. Motorola licenses the Software to the original customer and to any subsequent licensee for personal use only on the terms of this License. Motorola and its 3rd party licensors retain the ownership of the Software. You may: USE the Software only in connection with the operation of the Cable Modem. [. . . ]